Frigidaire FEB789WCCH Instructions D’installation

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
Your new wall oven has been designed to fit a limited variety of cutout sizes to make the job of installing
easier. The first step of your installation should be to measure your current cutout dimensions and
compare them to the cutout dimensions chart below for your model. You may find little or no cabinet
work will be necessary.
Do not remove spacers (if equipped) on the
side walls and/or on the back of the built-in oven. These
spacers center the oven in the space provided. The oven
must be centered to prevent excess heat buildup that may
result in heat damage or fire.
NOTE: Base must be capable of supporting
150 pounds (68 kg).
** NOTE: Allow at least 19 3 /8" (49.2 cm)
clearance for door depth when it is open.
NOTE: Dimension G is critical to the proper
installation of the built-in oven. If the oven
decorative moulding does not but against
the cabinet, or if noise is heard on
convection models, verify dimension G to
assure it is according to the required
dimension.
NOTE: For a cutout height greater than H
Min. dimension add one 2" (5 cm) wide
wood shim to each side of the opening
under the appliance side rails.
MODEL
26 7/8 (68.2) (•27 1/8 (68.9))
27" (68.6 cm) Wall Oven
30" (76.2 cm) Wall Oven
MODEL
24 7/8 (63.2)
27" (68.6 cm) Wall Oven
30" (76.2 cm) Wall Oven 28 1/2 (72.4)
All dimensions are in inches (cm).
Some models are not available in Canada.
(and Optional Electric or Gas Cooktop Combinaison)
** Door Open
(see note)
27" AND 30" WALL OVENS
PRODUCT DIMENSIONS
A
29 7/8 (75.9)
CUTOUT DIMENSIONS AND CABINET WIDTH
Min. F Max.
25 1/4 (64.1)
29 (73.7)
C
3
28
B
(71.4 cm)
r
Space
(78.7 cm)
D
A
2" (5 cm) Wide Wood
Spacer if Needed
* Suggested distance from floor is 31" (78.7 cm).
Minimum required distance is 4 ½" (11.4 cm)
• Dimension for stainless steel models.
Figure 1
B C (wrapper)
24 11/16 (60.6)
31 1/8 (79.1)
29 7/8 (75.9) 28 3/8 (72.1)
G (Min.)
Min.
23 1/2 (59.7) 28 1/8 (71.4)
24 (61)
28 1/8 (71.4)
1
Hole for
I
Cable
1
1 / "
2
(3.8 cm)
Min.
G
/ "
32
F
H
31"*
2" (5.1 cm)
Min.
25 3/8 (64.5)
25 3/8 (64.5)
.
H Max
30 1/8 (76.5) 27 (68.6) Min
28 7/8 (73.3) 30 (76.2) Min
P/N 318201507 (0201) Rev. C
English – pages 1-6
Español – páginas 7-13
Français – pages 14-20
Hole for
Cable
3" (7.6 cm)
Max.
Electrical
Junction Box
D
I