Generac Power Systems PowerWasher Manuel De L'opérateur page 11

5. Relieve spray gun pressure.
6. Place foot on footpad and secure unit
from movement when pulling recoil.
7. See Figure 3 -4. Firmly grasp the
recoil handle. Pull slowly until resis-
tance is felt. Then pull rapidly to start
engine.
After engine-start attempt, if engine fails to
run, always point spray gun in safe direction,
and squeeze spray gun trigger to release
high-pressure..
Figure 3 -4. Engine Recoil
A. Choke lever
8.
Return recoil handle slowly. DO NOT
let recoil snap back against recoil
housing.
9. When engine starts, slowly move
choke lever to OPEN position as
engine warms. If engine falters, move
choke lever to CLOSE position, then
to OPEN position.
B. Fuel valve.
Figure 3 -5. Fuel Valve and Choke
Operator's Manual for Power Washer
• If engine fails to start after six pulls,
move choke lever to "OPEN" position,
and repeat steps 6 through 9.
Power Washer Shut Down
IMPORTANT: Spray gun traps high-pressure
water, even when engine is stopped and water
is disconnected. Always point spray gun in
safe direction, and squeeze spray gun trigger
to release high-pressure. Engage trigger lock
when not in use.
1. Release spray gun trigger.
2. Turn engine switch OFF.
3. Squeeze
release high-pressure water.
4. Engage trigger lock.
5. Turn water supply OFF.
NOTE: Keep high-pressure hose connected to
pump and spray gun while system is pressur-
ized.
Apply Detergent
A
B
NOTE: DO NOT use caustic liquid with power
washer. Use ONLY power washer safe deter-
gents. Follow manufacturer instructions on
detergent label.Follow all manufacturer's
instructions on the detergent label.
spray gun trigger
9
and