Falcon Canopy hood Manuel D'instructions page 20

• Place the other wall bracket 1 against the wall, aligning it with the vertical line at a distance
X, measured as shown in fig. 2, equivalent to the height of the U-shaped upper section S
provided with the hood. The position X may vary, according to the various sizes of upper
chimney element available.
• Mark on the wall the centres of the keyholes for wall bracket.
• Pilot drill all the holes marked, using an 8 mm drill. Fix the wall brackets 1 and the rings
using the 8 mm rawl plugs and screws provided.
Splashback (optional)
When a splashback is to be fitted, the distance between the cooker hood and the cooking appli-
ances will be determined by the height of the splashback B and of any raised back on the bot-
tom units. The splashback is to be installed before installing the canopy. If the splashback is to
be fixed to the wall using both the top and bottom fixing holes care must be taken to ensure
that the splashback is fitted at the correct height before fixing it into position. The fitting
should be undertaken by a competent person with experience in this type of installation. If the
splashback is to be fixed through the top fixing holes only, proceed as follows:
• Put the splashback on the worktop as illustrated (fig. 2b), then hold it against the wall, en-
suring that it is correctly positioned.
• Mark the holes for the top fixing screws on the wall.
• Pilot drill the wall using an 8 mm drill and fix the splashback using the 8 mm rawl plugs
and screws provided.
• If the fixing holes in the bottom of the splashback are not to be used to secure the splashback
to the wall the installer should ensure that the bottom edge is tucked down behind the rear of
the worktop.
Fixing the canopy
• Fasten the angle iron L to the hood
canopy C (fig. 3) using the five 2.9 x
9.5 screws provided. If a ducting ver-
sion of the hood is to be used, ensure
that the two holes 1 are left open, as
these will later serve to connect the
evacuation spigot A.
• Hook the hood canopy C to the
lower rings (fig. 4).
• Remove the metal grease filters (see
paragraph Maintenance).
• Vertically adjust the canopy and
align it horizontally b y turning the
screws V1 (fig. 5).
• Turn the screws V2 until the hood is
tightly locked against the wall (fig.
5).
EN
L
V1
V2
A01_05
Fig.3
Fig.4
Fig.5
2
20
0