Introduction; Safety Precautions; Where To Install The Radiator - S&P EMIDRY-D Manuel D'installation

1. INTRODUCTION

Thank you for purchasing one of our radiators. You have purchased a high-
quality product manufactured in full compliance with applicable safety
regulations and with EU standards.
Please read these instructions carefully before installing and switching on the
radiator. Keep these instructions in a safe place for future reference.
Please check that the appliance is in perfect condition when you unpack it, as
all factory defects are covered by the S&P guarantee
.

2. SAFETY PRECAUTIONS

- The guarantee does not cover any damage sustained by the appliance as a
result of the failure to follow the indications given in this Instructions Manual.-
Check that the mains voltage matches the voltage indicated on the appliance's
specifications plate.- Electric radiators may not be used in the presence of
gases, explosives or flammable materials.- No objects, including the connector
cable, should enter into contact with the appliance.- Do not cover the appliance
or use it for drying clothes.- Surfaces of the heater may become very hot. Small
children should be kept under supervision when near the appliance.- Never
install the appliance beneath a power socket.- Always isolate the power before
removing the cover of the appliance.- If the power cable is damaged it should
be replaced by an authorized installer, as such an operation requires special
tools.- To avoid overheating, do not cover the appliance.- This appliance is not
suitable for use by persons (including children) whose physical, sensorial or
mental capacities are impaired, or who lack the appropriate experience and
knowledge necessary for its use, unless acting under the supervision or
instructions of a person responsible for their safety.- Children should be kept
under supervision to ensure they do not play with the appliance.
- This appliance (CLASS II / IP24) may be installed in bathrooms zone 2 on
condition that it is fitted with a high-sensitivity 30mA residual current device.
Under no circumstances should the appliance be installed in zones 0 or 1. (See
figure 5) When installed in a bathroom, the appliance should be located in such
a position that its controls cannot be reached by persons using the bath or
shower.
NOTE: Certain products used in the manufacture of this appliance (paints,
lubricants, resins etc.) may give off a certain odour when the appliance is
connected for the first time. This phenomenon is perfectly normal and harmless,
and disappears totally after a few hours of use.

3. WHERE TO INSTALL THE RADIATOR

The appliance should be wall mounted in a place unobstructed by furniture.
Avoid installing the appliance in a place where it is likely to be obstructed by
other objects such as furniture, curtains or other appliances.When installing in a
14