DCS TDS1-20 Instructions D’installation page 8

7a DISCARD PACKAGING
Model may vary from illustrations shown
REMOVE ALL DRAWERS TO ACCESS SCREW HOLE LOCATIONS
8a
To remove the drawer(s)
Remove the drawers by pulling them
1
out until the slider latch is visible.
Carefully push the latch down on the
2
left side, while lifting up the latch on
the right side.
3 Pull the drawer out of the frame.
Note: to prevent damage to surfaces, place
the drawers on a stable surface on a
protective towel or table cloth.
INSTALLING DRAWER UNITS, WASTE BASKET
Inspect the product(s) to verify that there is no shipping damage.
If any damage is detected, call the shipper and initiate a damage claim.
DCS by Fisher & Paykel is not responsible for shipping damage.
NOTE: Do not discard any packing material until the unit has been inspected.
Operate the drawers to be sure they glide smoothly.
Recycle responsibly
Examine the fronts to be sure there are no dents or scratches or discoloring.
Left Slider latch
8
Right Slider latch