Chamberlain 920GAC Manuel D'instructions

WIRELESS GATEBELL KEYPAD
MODEL 920GAC
LEARN
CARTON INVENTORY
PRESS
TO
PRESS Remote Control
R ING
TO
PRESS
R ING
TO
Receiver
R ING
Keypad
PRESS
TO
RING
Drywall Anchors (2)
INSTALLATION • MOUNT RECEIVER
TABLETOP MOUNTING
1
LEARN
Insert remote control and power
adapter into receiver. Plug into outlet.
®
INSTALLATION • MOUNT KEYPAD
NOTE: For optimal range performance, mount the receiver to an external wall that is close to the gate operator. DO NOT MOUNT TO METAL.
1
PRESS
TO
R ING
PRESS
TO
Program remote control to the gate
RING
operator radio receiver. Refer to your
gate operator manual for programming
instructions.
PRESS
TO
RING
Power Adapter
3
Bottom
Screws (4)
Mounting
Hole
Remove battery cover and battery.
Determine location for keypad. Mark the
bottom mounting hole.
5
Install top mounting screw, allowing
1/8" (3.2 mm) to protrude above surface.
Position keypad on screw head and adjust
for snug fi t.
PRESS
TO
RING
Lift
Battery
Battery Cover
LEARN
LEARN
2
PRESS
TO
RING
Remove foam spacer on underside of
keypad cover. Check range before installing.
Using two people, hold the keypad and
receiver in the desired locations. Make sure
the keypad rings the gatebell when pressed.
If no chime is heard, repeat test using a new
location for the receiver.
4
Top Mounting Hole
LEARN
For the top mounting screw, mark 4
1/4" (10.8 cm) up the centerline from
the bottom of the keypad. Drill 1/8" pilot
holes for top and bottom screws.
See keypad mounting reference.
6
LEARN
LEARN
LEARN
Secure keypad with bottom screw, using
LEARN
care to avoid cracking plastic housing.
Reinstall battery and slide battery cover
up and snap it into place. Close cover.
KEYPAD MOUNTING
(For reference only)
LEARN
4 1/4"
(10.8 cm)
LEARN
LEARN
LEARN
LEARN
LEARN
LEARN
LEARN
LEA
LEARN
LE
LEARN