Buffalo Pro Mode D'emploi page 7

Igniting the Hokker
1. Place the pan carrier .
2. Turn the knob to the "normal" position. keep the knob pressed and press the ignition button a few times
until the burner is burning completely. Keep the knob pressed in for approximately a further 10
seconds. The burner will continue to burn.
Turning off the gas griddle:
3. Turn the knob completely to the right. The burner will go out.
Note! After turning off the burners, wait approximately 10 minutes before reigniting the burners.
After turning off the burners, always turn off the main tap on the gas supply!
Problems:
gas ring will not light:
gas ring does not light fully:
comment:
• It is recommended to replace the gas hose after 3 or 4 years ( see date shown on hose ). The
gas hose becomes porous after a time.
• Consult the local regulations, these may differ.
Guarantee
Any defect affecting the functionality of the appliance which becomes apparent within one year of its purchase
will be corrected by free repair or replacement provided that it has been used and maintained in accordance
with the instructions and has not
been abused or misused in any way. Your statutory rights are not affected. If it's
under guarantee, state where and when it was bought, and include proof of purchase (e.g. till receipt).
In line with our policy of continuous product development we reserve the right to change product, packaging
and documentation specifications without notice.
Discard
At the end of the life of the appliance, please dispose of the appliance according to the regulations and
guidelines applicable at that time.
possible cause
- ignition defective
- thermocouple defective
- igniter dirty
- gas hose kinked
- injector blocked
- gas hose kinked
- gas tap not fully open
- main injector blocked
- gas tap defective