CompuSTAR R1600 Guide D'utilisation page 4

Step1:
Activate Valet/ Programming mode by manually
turning the ignition on and off five times (between Acc and
On)with car key within a 7 second period.
The parking lights will flash once with successful completion of
this step.
Step2 :
Within a 7 second period after cycling the ignition for the 5
Press the button for a 1/2 sec. The car parking lights will flash
once to confirm that the transmitter has been programmed.
You can continue programming the additional remotes. The parking
lights will flash two times when the programming mode has expired.
Reservation Mode (manual transmission only)
In order to auto-start your manual transmission vehicle, you must first set the CompuStar
system to Reservation Mode before leaving your vehicle. The purpose of Reservation
Mode is to leave the transmission gear in the neutral position when you leave your
vehicle. Reservation mode is intended for use on MANUAL TRANSMISSIONS ONLY
and NOT FOR AUTOMATIC TRANSMISSIONS. Reservation Mode must be engaged
each and every time you leave your manual transmission vehicle in order to auto-start it.
Note : The system is not recommended for manual transmission vehicles with
removable or convertible tops.
Important Requirements to activate Reservation Mode
The transmission must be in the NEUTRAL position.
The vehicle windows must be rolled up.
Do not set the reservation mode with people in the vehicle.
Do not auto-start the vehicle with people inside it.
Activating Reservation Mode ( MANUAL TRANSMISSION ONLY )
Step1 :
After arriving at your destination, and BEFORE TURNING YOUR
ENGINE OFF, place the transmission in the Neutral position.
Step2 :
Activate the parking brake.
Step3 :
Remove your foot from the foot brake.
Step4 : Remove the key from the ignition, and the engine will remain running.
Page 6
Step5 :
Valet Mode
While the vehicle is in valet mode, the only features that will function will be the keyless
th
time,
entry and optional auxiliary functions.
In order to enter Valet mode, press the
second. In order to manually enter Valet Mode, insert your key into the ignition and turn
the ignition on and off
Diagnosing problems with Auto-Start
If there is a problem in auto-starting your vehicle,the the CompuStar system will
do one of two things; if it fails for any of the reasons listed in the table below, it will
flash the parkinglights three times then flash the error number. Otherwise, it will
attempt to start the vehicle three times. If, after three times, the vehicle will not
start or stay running, the the CompuStar system will shut down. In either case,
please see your istaller to resolve the situation.
Error Number
(# of times the car chirps & parking lights flash)
Exit the vehicle and close the door within two minutes after activating
the parking brake. The engine will shut off and reservation mode for
the remote starter is now complete.
buttons simultaneously for a 1/2
five times within 7 seconds
(between ACC and ON)
You can exit Valet Mode only by pressing buttons
simultaneously for 1/2 second..
Error Reason
1
2
3
4
5
6
7 Reservation Off (Manual Transmission Only)
Page 7
Engine On
Key On
Door Open
Trunk Open
Brake On
Hood Open