Canon RS-CL17 Manuel De Montage Et D'installation page 15

Adjust the Projection Angle
Turn on the projector, project an image, and then adjust the projection angle and screen slant angle.
● After completion of adjustment, tighten the screws and check that every fitting is secured firmly.
● Be sure to hold the projector from falling until the Ceiling-mount bracket and Base bracket are
secured firmly.
Caution
Adjust the vertical
projection angle.
F
G
Adjust the horizontal projection angle
1 Loosen two wing screws
(H). Move the projector
horizontally to adjust the
horizontal projection angle.
2 When the projector is correctly positioned, tighten
the wing screws.
Adjust the vertical projection angle
1 First loosen four screws (F) and then
loosen two wing screws (G). Move the
projector vertically to adjust the vertical
projection angle.
2 When the projector is correctly positioned,
first tighten the wing screws (G) and next
tighten the four screws (F).
Adjust the screen inclination
1 Loosen four screws (B), and then adjust
the slant angle of the projector.
2 When the projector is correctly positioned,
tighten the four screws (B).
Adjust the horizontal projection angle.
Adjust the screen slant angle.
B
5°
5°
F
5°
20°
B
5°
5°
H
H
13