Installation Instructions; Before Using Your Appliance; Installation Of Your Appliance - Avanti Ff18F0W Manuel D'instructions

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Remove the exterior and interior packing.

Check to be sure you have all of the following parts:

3 Refrigerator Shelves

2 Vegetable Crispers

1 Glass Crisper Cover

1 Instruction Manual

1 Freezer Shelf

2 Freezer Door Bins

Before connecting the unit to the power source, let it stand upright for approximately 2 hours.

This will reduce the possibility of a malfunction in the cooling system from handling during

transportation.

Clean the interior surface with lukewarm water using a soft cloth.

Place your refrigerator-freezer on a floor that is strong enough to support the refrigerator-

freezer when it is fully loaded. To level your refrigerator-freezer, adjust the leveling legs at the

bottom of unit.

Allow 5 inches of space between the back and sides of the unit, which allows the proper air

circulation to cool the compressor and condenser.

Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.).

Direct sunlight may affect the acrylic coating and heat sources may increase electrical

consumption. Extreme cold ambient temperatures may also cause the refrigerator- freezer not

to perform properly.

Avoid locating the unit in moist areas.

Plug the unit into an exclusive properly installed-grounded wall outlet. Do not under any

circumstances cut or remove the third (ground) prong from the power cord. Any questions

concerning power and/or grounding should be directed toward a certified electrician or an

authorized Avanti Products service center.