Table des Matières
Publicité
VERIFICATION OF WARRANTY REGISTRATION
DEALER WARRANTY INFORMATION & REGISTRATION VERIFICATION
It is imperative that the selling dealer registers this machine with Twose of Tiverton Limited
before delivery to the end user – failure to do so may affect the validity of the machine
warranty.
To register machines go to the Twose web site at www.twose.com, log onto 'Dealer
Inside' and select the 'Machine Registration button' which can be found in the Service
Section of the site. Confirm to the customer that the machine has been registered in the
section below.
Should you experience any problems registering a machine in this manner please contact
the Twose Office on 01884 253691.
Registration Verification
Dealer Name: ................................................................................................
Dealer Address:
Customer Name: ............................................................................................
Date of Warranty Registration:
NOTE TO CUSTOMER / OWNER
Please ensure that the above section above has been completed and signed by the selling
dealer to verify that your machine has been registered with Twose of Tiverton Limited.
IMPORTANT: During the initial 'bedding in' period of a new machine it is the customer's responsibility
to regularly inspect all nuts, bolts and hose connections for tightness and re-tighten if required. New
hydraulic connections occasionally weep small amounts of oil as the seals and joints settle in – where
this occurs it can be cured by re-tightening the connection – refer to torque settings chart below. The
tasks stated above should be performed on an hourly basis during the first day of work and at least
daily thereafter as part of the machines general maintenance procedure.
HYDRAULIC HOSE ENDS
BSP
Setting
1/4"
3/8"
1/2"
5/8"
3/4"
1"
125 Nm
1.1/4"
190 Nm
1.1/2"
250 Nm
2"
420 Nm
IMPORTANT
............................................................................................
....../....../......... Dealer Signature: ..........................
TORQUE SETTINGS FOR HYDRAULIC FITTINGS
Metric
18 Nm
19 mm
31 Nm
22 mm
49 Nm
27 mm
60 Nm
30 mm
80 Nm
32 mm
41 mm
50 mm
55 mm
70 mm
PORT ADAPTORS WITH BONDED SEALS
BSP
Setting
1/4"
34 Nm
3/8"
47 Nm
1/2"
102 Nm
5/8"
122 Nm
3/4"
149 Nm
1"
203 Nm
1.1/4"
305 Nm
1.1/2"
305 Nm
2"
400 Nm
Metric
19 mm
22 mm
27 mm
30 mm
32 mm
41 mm
50 mm
55 mm
70 mm
Publicité
Table des Matières
