Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
C)
Remove the plastic floor from the base of the incubator, as it is
necessary only for hatching (last 3 days). DO NOT LEAVE IT INSIDE THE
MACHINE DURING INCUBATION!
NB: store the plastic floor on a flat surface so that it won't deform.
D)
Ensure that the egg tray is in the correct position (on its supports) and that the cradle rows tilt freely in the two
directions.
E)
Fill basin 5/a with lukewarm water. Pour the water into the
corresponding opening at the front left hand side of the incubator. Do
this slowly, taking care not to allow the water to overflow from the basin:
too much liquid would increase in the humidity rate lowering the
hatching percentage. The second basin (5/b) will be used only for the
hatching phase.
F)
Replace the lid. Ensure that the edge of the lower box locates perfectly
with the slot in the lid.
27
Publicité
Table des Matières
