Sunex Tools 8514 Instructions D'assemblage

SUNEX
TOOLS
ASSEMBLY INSTRUCTIONS
AWARNING
• Read, study, understand
• It is the responsibility
responsibility of the device owner to keep this manual intact and in a convenient
manual or product labels are lost or not legible, contact Sunex@ for replacements.
English, the product and safety instructions
language by the purchaser/owner
• Do not exceed weight capacity of 300 lbs.
• Inspect before every use. Do not use if parts are loose or damaged
• Wear gloves when lifting edges.
• Keep children away from unit.
• Do not sit on edge of seat. Stool can tilt or tip over causing damage or personal injury
• Do not stand on or use
• Stool is designed to roll easily on flat surfaces and should not be used on uneven or inclined surfaces.
• Do not expose to heat as some parts of this product are under pressure.
• Do not use (or modify) this stool for any other purpose than that for which it was designed.
• Do not remove any labels. Replace any damaged labels.
• Failure to heed these warnings may result in personal injury
and/or property damage.
WARNING: This product can expose you to chemicals including nickel
which is known to the State
defects or other reproductive
www.P65Warnings.ca.gov.
Assembly Instructions:
I. Insert the painted end of the lift cylinder into center hole on top
of round metal base. To avoid damaging the cylinder, do not
force or hammer cylinder into the hole.
2. Place seat on top of the unpainted end of the lift cylinder. As with
the lift cylinder in Step #1 , do not force or hammer the seat onto
the cylinder.
3. To lock seat and cylinder into place, slowly add your weight to
the seat by sitting on the seat for approximately
The cylinder and the seat will lock into place automatically.
Care Instructions:
Your professional shop seat is designed to give you worry-free
service with little to no maintenance.
for periodic oiling or maintenance of the seat or cylinder. Simply
clean with a damp cloth. Avoid contact with harsh chemicals
• Replacement air cylinder available as part # RSTSAC
• Replacement caster with washer and nut available as part # RS8515CS
• Replacement plate with seat lever available as part # RS8509SLTS
and follow all instructions
of the owner to make sure all personnel read this manual prior to using the device. It is also the
shall be read and discussed
or his designee, making sure that the operator comprehends
as cart.
of California to cause cancer
harm. For more information go to
10 seconds.
There should be no need
before operating this device.
with the operator in te operator's
and birth
TRACTOR
location for all to see and read. If the
if the opeartor is not fluent in
native
its contents.
O Copyright 2020, Sunex Tools@
8514
SEAT
Rev. 4/29/20