Dorman 601-082 Mode D'emploi

601-082
WIRELESS
IGNITION MODULE
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2025 No reproduction in whole or in part without prior written approval.
601-082_Tech-Note_v2
PROGRAMMING UNIQUE CODE TO
WIRELESS IGNITION MODULE
Unique code required for wireless ignition module programming. Contact dealer with VIN to get code or
pull code from vehicle using a capable scan tool. This code is programmed and stored in wireless ignition
module, powertrain control module (PCM) and each ignition key transponder chip. When PCM or wireless
ignition module is replaced, it is necessary to program code into new module using a diagnostic scan tool.
NOTE: If three attempts are made to enter secure access mode using an incorrect PIN, vehicle
will enter lockout mode for one hour. To exit lockout mode, switch ignition to key on, engine
off position for one hour and then enter correct PIN. Be certain that all accessories are turned
off. Charge battery during this time to ensure proper voltage.
CAUTION: If replacing both PCM and wireless ignition module, PCM must be programmed
before wireless ignition module.
PROGRAMMING WIRELESS IGNITION
MODULE ONLY
CAUTION: Familiarize yourself with all steps of procedure before beginning.
STEP 1:
Connect battery charger to vehicle.
NOTE: Have unique vehicle PIN readily available before programming.
STEP 2:
Connect scan tool.
STEP 3:
Follow steps on scan tool for wireless ignition module replacement.
STEP 4:
Enter PIN when prompted.
STEP 5:
Cycle ignition on and then off again once after successful routine completion.
PCM/WIRELESS IGNITION MODULE
PROGRAMMING
When PCM and wireless ignition module are replaced at same time, perform following steps in order:
STEP 1:
Program PCM.
STEP 2:
Program new wireless ignition module (follow Steps 1-5 above).
STEP 3:
Program all ignition keys to new wireless ignition module. No ignition cycling is needed.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
PAGE 1 OF 3