Progress Lighting 2618 Mode D'emploi

This remote control IS designed to separately control your ceding fan speed and I ght brightness.
These are four buttons (HI, MED, LOW, OFF) to control the fan speed and off
The light button Will control light on and off.
The red Indicator on the transmitter WII light when the button IS pressed
INSTALLATION AND OPERATING INSTRUCTION
1 . SETTING THE CODE
This unit has 16 different code combinations.
A. Setting the code on the transmitter:
a. Removed battery cover. Press firmly be ow arrow and slide battery over off
b. Side code switches to your choice of up or down position. (Factory setting s
al up. Do not use this position. Use a smal screwdriver
slide firmly up or down (Figure 1)
B. Setting the code on the rec•ever:
a. slide code switches to the same positions as set on your transmitter
b. Replace battery cover on transmitter.
SWITCHES
(FIG.
2. INSTALLING RECEIVER IN CEILING
A Safety Precautions
WARNING. HIGH VOLTAGE! Disconnect
Do not use with sol d state fans
Electrical wiring must meet all local and national electr•ca code requirements
Electrical source and fan must be 115/120 volt, 60 Hz. Maxmum
Household electrical power can cause serous
B. Instal ing Receiver •n Fan
a. Remove electr cal power from the circuit.
b. Remove ceding fan canopy from the mounting bracket.
c. Disconnect exsting Wiring between ce ling fan ans supply at electr•ca junction box.
d. Make connections as follows, using the wire nuts supplied
CONNECT
Green fan wre
Black receiver wre (AC IN L)
White receiver wire (AC IN N)
Whlte rece,ver wre (TO MOTOR N)
Black receiver wre (TO MOTOR L) .Black fan wre
Blue receiver wire (FOR LIGHT)
If other fan or supply wres are different color, have this unit installed by qualified licensed
e Push all connected wres up nto junction box
f. Lay the black antenna Wire on top of the receiver, and put the receiver in the mounting bracket
g. Reinstall the canopy on the mounting bracket.
h. Restore electr cal power.
Remote
GENERAL
To set the code, perform these steps
or bal point pen to
(Figure 2)
RECEIVER
FAN
source of electrical power by removing fuse or switching off circuit breaker.
fan motor amps. 1.0, Maxmum
injury or death!
TO
Bare supply wre
Black supply wire
White supply wire
White fan wre
Blue I ght wre
Control
INFORMATION
2618
coos
(FIG.
light watts. 300
SUPPLY
(FIG.
SLUE
GREEN
PAGE I Of 4
RECEVER
(FIG.
SLUE
SPEC NO 93017549 12/01/08