Install Cooktop - Jennair 24 Instructions D'installation

To Install Brackets into Wood Countertop:
1. Measure the center line of the vertical sides of the cooktop
cutout.
2. Position brackets in the center of the vertical centerline and
align the upper edge of the brackets so that they are flush
with the countertop.
3. Attach the brackets in the cutout with the screws provided.
A
B

Install Cooktop

WARNING
Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury.
1. Using 2 or more people, place the cooktop upside down
on a covered surface using the foam end posts from the
packaging.
2. OPTIONAL - Remove the foam roll from the package
containing literature. Apply foam adhesive-side down around
the bottom of the cooktop glass.
NOTE: The foam helps avoid damage to the underside of the
cooktop glass from debris and helps the cooktop sit flat on
uneven counters.
A. Cooktop base
B. Foam
C. Assembly glass
Center line
A. Bracket
B. Screw
A
B
C
3. Lower the cooktop into the cutout with the back end of the
cooktop angled down.
4. Make sure that the clips on each side of the cooktop line up
with the brackets in the cutout.
A
5. Push down on cooktop to snap the cooktop clips onto the
brackets installed in the cutout.
A
A. Induction cooktop
B. Cooktop cutout
Front side
A. Clip
B
7