Safety Instructions - Proplus 390059V01 Notice D'utilisation

INDEX
INTRODUCTION
SAFETY INSTRUCTIONS
TECHNICAL DATA
ASSEMBLY
MAINTENANCE
DISPOSAL
WARRANTY
SERVICE
i
INTRODUCTION
Read these operating instructions carefully before using the product. Keep these operating instructions in a
safe place. These instructions must be passed on to any subsequent users of the product. The tyre stand is
intended for the storage of wheel rims with or without tyres. The manufacturer accepts no liability in the
event Of the product being a tered or used for Other purposes.
SAFETY INSTRUCTIONS
• Place the tyre stand only on a level, flat and solid surface. The base must not slope, as the stability
of the rack cannot then be guaranteed.
• The tyre stand may not be used for any other purpose
• The tyre stand may not be moved when supporting
it could tip over.
• The tyre stand may not be tipped since this could cause injury.
• The tyre stand may not be used if damaged since this could cause injury.
• Keep children away from the tyre stand.
TECHNICAL DATA
- Suitable for all common car wheel rims with tyre widths up to 295mm
Materials: steel, aluminium,
ASSEMBLY
Decide on the final location for your tyre stand before putting the wheels on to it.
1) First of all fit the central linking piece and the extension legs together. Fasten with
the screws supplied (if necessary a rubber hammer can help with this)
2)
Insert the middle rod section (without plug) into the central linking piece Put the
pin through the lowest hole and fit the plate
3) Place the first tyre (fitted to its rims) on the stand. Repeat the procedure in the same
way for the next tyre
4) Now attach the end rod section (with plug)
5) Continue as above until all four wheels are correctly stored.
INDEX
(Use spirit level to check.)
PP
6
since this could cause injury.
a load (rims + tyres) since there is a danger that
6
6
6
6
6
7
7
7
7
1
1