Zircon Breaker ID Pro Mode D'emploi
Les langues disponibles
Les langues disponibles
Breaker ID Pro
Circuit Breaker Finder
Transmitter
Accessories
Visit www.zircon.com/support
for the most current instructions.
LIMITED 1 YEAR WARRANTY
1. EQUIPMENT RATINGS
Receiver
2. INSTALLING THE BATTERY
3. LOCATING A CIRCUIT
Note: A small percentage of circuit boxes are mounted
with breakers oriented vertically. See diagrams for
proper receiver orientation.
Breaker ID Pro Transmitter be used where the voltage across
the transmitter exceeds 277 V AC, as this will cause failure of
the device with consequent damage beyond repair.
Perform a second pass over the breakers.
4. CLEANING AND STORING THE UNIT
5. HELPFUL HINTS
In no event may the
https://manual-hub.com/
YES
NO
Situation
Probable Causes
Solutions
Manuels Connexes pour Zircon Breaker ID Pro
Sommaire des Matières pour Zircon Breaker ID Pro
- Page 1 5. HELPFUL HINTS In no event may the Situation Probable Causes Solutions Breaker ID Pro Transmitter be used where the voltage across the transmitter exceeds 277 V AC, as this will cause failure of the device with consequent damage beyond repair. https://manual-hub.com/...
- Page 2 5. CONSEJOS UTILES Situación Causas Probables Soluciones En ningún caso se debe usar el Trasmisor Breaker ID Pro en instalaciones en las que la tensión exceda 277 V CA, ya que esto dañará la unidad sin posibilidad de reparación. https://manual-hub.com/...
- Page 3 5. CONSEILS UTILES Situation Causes Probables Solutions L´émetteur Breaker ID Pro ne doit en aucun cas être utilisé lorsque la tension est supérieure à 277 V c.a., car cela entraînera la défaillance du dispositif ainsi que des dommages non réparables.