Extreme Max 1229.4029 Manuel D'instructions

-naäuC7$
IMPORTANT:
If the intended battery is completely
Efficiency Wall Mount Battery Maintainer
limits set by the charger's safety circuit.
A WARNINGS:
Read Before Use.
• Do not attempt to use this product to charge dry-cell
• Never operate battery charger
through the casing.
• Keep away from any liquids, including
• Keep battery and charger away from open flame. No smoking.
• All accessories in the vehicle must be turned off or disconnected
• During extended use, such as during storage, periodically
warm, disconnect the battery
• Use battery chargers only for their intended voltage ratings.
• Lead-acid batteries may emit gas that may become combustible.
• Operation is not intended for children, operation
REMOVING BATTERY
I. All accessories in the vehicle
black) wire first, followed
2. Clean battery terminals.
3. Connect charger to battery before connecting
first, followed by Negative
4. Lastly, plug charger into electrical
Note: For unsealed batteries,
CHARGER INFORMATION:
• Charger may be connected
operating normally.
• Three modes are available
a. Bulk Mode: Full charge strength for low charged batteries
b. Absorption Mode: High constant voltage for mostly charged batteries
c. Storage Mode: Low constant voltage for fully charged batteries
• Charge time depends on both battery size and condition
9 hours to get to 80%, while a large vehicle battery may take multiple
TROUBLESHOOTING:
• If no charger lights are on, the charger is not receiving
outlet is functional.
• When green light does not turn on for an extended
are pulling power from battery. There is a chance the battery may be defective
Be aware that large batteries
may take a longer initial charge.
• If green light is followed by a red light, there may be an appliance
appliance. If no appliance
• If a green light is seen instantly
Customer Service: 651-357-1862 | service@extrememax.com
High Efficiency
dead with a charge of less than 3 volts, the High
will not operate.
without first checking
precipitation.
charger and consult a professional
should be performed
FROM VEHICLE FOR CHARGE:
must be turned off or disconnected
by Positive ( + red).
Wear proper eye protection
charger to electrical
( - black) clamp to Negative terminal.
outlet.
follow manufacturer
for extended use. If so, periodically
for charger:
amount of time, look to see if other appliances,
may take a longer time to reach full charge. New batteries
can be found, recheck battery connections
on hookup, the battery may already be full.
Wall Mount
Operating Instructions
At least 3 volts in the battery are required
batteries. This unit is intended to charge lead-acid batteries
the wiring for damage. Do not use if wires are broken or exposed
Keep charger dry.
to prevent spark before charging.
check the temperature
as to battery care.
Follow manufacturer's
by adults only.
to prevent spark. Loosen and remove Negative
to avoid battery corrosion
outlet. Positive ( + red) clamp to Positive terminal
Do not allow clamps to touch once attached.
directions for battery
check both the battery and the charger to see that they are
of the battery. Normal 15 Amp-hour
days to reach a high charge.
power from the electrical
and will not be able to reach a full charge.
pulling power from the battery. Turn off or remove that
to ensure a good connection.
Battery Maintainer
1229.4029
for operation
of the charging battery. If it is unusually
charging guidelines.
and debris coming in contact with eyes.
removal.
batteries take approximately
outlet. Check connection and ensure
such as vehicle lights,
may not be fully charged and
I ExtremeMax.com
due to
only.
( -
2700ex0616