PRO-POINT 8879967 Mode D'emploi page 4

8879967
ASSEMBLY
Numbered references
1. Slide the pneumatic
center opening.
2. Fit the seat onto the pneumatic
for a friction
Lock the pneumatic
3.
the seat and remaining
Adjust the seat height by pulling the seat lever upward. Remain seated
4.
to lower the height or stand while pulling the lever to raise the height.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition
to control
2. Inspect the tool components
or worn components.
servicing.
3. When not in use for an extended
before using the tool again.
WARNING! Only qualified
An improperly
and/or others.
CLEANING
Wipe the surface with a clean, moist cloth.
TROUBLESHOOTING
Visit a Princess
properly or parts are missing. If unable to do so, have a qualified
technician service
4
400 lb Heavy Duty Adjustable
& INSTALLATION
in parenthesis
cylinder's
fit.
cylinder in place by slowing adding your weight to
seated for approximately
and will have fewer problems.
Only use identical replacement
service
repaired tool may present
Auto Ltd. location
the tool.
Shop Stool
(#1) refer to the included
(#2) large end into the base's (#1)
cylinder's narrow end and push down
periodically. Repair or replace damaged
period, tighten the connections
personnel
a hazard
for a solution if the tool
For technical
Parts List.
10 seconds.
is efficient, easier
parts when
should repair
to the user
does
questions call 1-800-665-8685
the tool.
not function