Extreme Max 3005.4098 Instructions De Montage

-naäuC7$
Warnings:
- Make sure all hardware is securely fastened
- Beware of potential pinch points.
- Do not throw the rake at people, animals or things.
- When you are not using the rake. Make sure the tines are facing downward
Includes:
(2) Arm Braces......................................A
(1) Extension Handle..............
(1) Rake Head...
(2) 1/4"-20 x 5/8" Hex Bolts..........
(1) 1/4"-20 x 1-1/2" Hex Bolt...............
(1) 1/4"-20 x 1-3/4" Hex Bolt................G
(5) 1/4" Lock Nuts.................................H
(1) Eye Bolt.... ..... ..................
(2) Velcro Straps....... ...........................J
(1) Float.....
(1) End Cap.......................
Figure 1
Assembly Instructions:
1. Place the slotted end of the handle onto the flat edge of the rake head, aligning
hole. Place the 1/4"-20 x 1-1/2" hex bolt through
2. Attach the flat end of a brace piece to the rake head using one of the remaining
Curved edge of brace piece should be near the handle. Do not tighten
3. Attach the curved edges of the brace pieces next by aligning
1-3/4" hex bolt through the aligned hole.
4. Being careful not to over-tighten,
5. Line up the float against the rake head and attach with Velcro straps. (See Figure 2)
Customer Service: service@extrememax.com
Floating Lake Rake Assembly
before use.
..c
......E
F
the aligned holes. Do not tighten
snug each of the four nuts.
to prevent serious harm or injury.
E
Figure 2
the end handle hole with the center head
nut. (See Figure I)
holes and a 1/4"-20 x 5/8" hex bolt.
nut. Repeat for second brace piece.
both brace holes with the handle hole. Place the 1/4"-20 x
I www.extrememax.com
Instructions
3005.4098
o
3399ex0120