Installing The Water Filter; Replace The Water Filter - Jennair JUIFN15HX Guide D'utilisation Et D'entretien

GETTING STARTED

INSTALLING THE WATER FILTER

A water filter is provided but not required for this
unit. Minerals are expelled during the ice production
process, making a water filter unnecessary. For
information on where to purchase replacement
filters, see "To Order Accessories" in the "Assistance"
section on page 14.
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
8 | GETTING STARTED
REPLACING THE WATER FILTER
Replace the disposable water filter when indicated on
the water filter status display, 9 months has passed,
or ice production has decreased significantly.
1.
Take the water filter out of its packaging and
remove the cover from the O-rings. Be sure
the O-rings are still in place after the cover
is removed.
B
C
D
A. Cover C. Alignment pin
B. O-rings D. Alignment arrows
2.
The water filter compartment is located to the
right of the ice maker controls behind the control
door housing. Push in on the control door
housing to release the latch, and then lower the
door.
A
A. Door
3.
Turn the water filter counterclockwise, and pull it
straight out of the compartment.
NOTE: There may be some water in the filter.
Some spilling may occur.
4.
Using the arrow pointing to the alignment pin (A)
on the side of the filter and the arrow inside the
control housing (E), match the alignment pin with
the cutout notch and insert the filter into
the housing.
A
F
A. Alignment pin
B. "Unlocked" symbol
C. "Locked" symbol
D. Cutout notch inside
control housing
5.
Turn the filter clockwise until it locks into the
housing. Ensure that the alignment arrow on the
filter head aligns with the locked symbol on the
control housing.
NOTE: If the filter is not correctly locked into the
housing, the ice maker will not produce ice.
A. Alignment arrow lined up with "Locked" symbol
6.
Push the control door until the latch snaps
closed.
C
B
D
E
A
E. Arrow pointing
to cutout notch
F. Arrow pointing
to alignment pin
A