SIGNIFY SunStay Pro gen2 mini Mode D'emploi
SunStay Pro gen2 mini
VGP724 Off Grid
The luminaire should be positioned so that prolonged staring into
the luminaire at a distance closer than 0,384 m is not expected
Connect the battery for luminaire operation
This luminaire must be installed by qualified personnel only
Disconnect battery and panel before servicing
Use gloves to install/service the luminaire
Always follow this mounting instructions to fix the luminaire
Never modify the luminaire nor the fixation locations for installation
Risk of accident due to incorrect tightening torque
583 - 443000023003
QR
2025-08-26
15 x 15
© Signify Holding
All rights reserved
07
IK
09
66
IP
IK
PV panel
1/12
outdoor
Data subject to change without notice
Keep for future reference:
i+
QR
21x21
Scan me!
DOWNLOAD
Service tag
QR
21x21
Scan me!
DOWNLOAD
4-10
www.signify.com
Table des Matières
Manuels Connexes pour SIGNIFY SunStay Pro gen2 mini
Sommaire des Matières pour SIGNIFY SunStay Pro gen2 mini
- Page 1 21x21 Scan me! DOWNLOAD SunStay Pro gen2 mini Service tag 21x21 Scan me! VGP724 Off Grid DOWNLOAD outdoor 4-10 PV panel The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than 0,384 m is not expected...
-
Page 2: Dimensions
Dimensions Weight SunStay MINI OG 18Ah 19,1 kg SunStay MINI OG 12Ah 18,0 kg S.Cx values Energy efficiency class 2/12... - Page 3 For optimal performance of the luminaire contact your local SIGNIFY employee for solar sizing and configuration. The installation of the luminaire is not recommended under these conditions: The luminaire performance and battery charging can be affected by external parameters. Additional photovoltaic vertical panels can be fixed to the pole.
-
Page 4: Luminaire Orientation
Spigot fixation Luminaire orientation Post Top (PT): Side Entry (SE): Ø76mm or Ø60mm Only Ø60mm Spigot into pole Open luminaire only if base is supported or if luminaire is installed on the pole 4/12... - Page 5 Sensors and type of luminaire Sensors and type of luminaire Sensors and type of luminaire 5/12...
-
Page 6: The Luminaire Type A Or B Can Be Upgraded To C Or D
Disconnect Battery and PV panel first before disconnecting or upgrading the product from A or B to C or D Luminaire A or B: Charge Controller CC G5 is connected to BLE Bluetooth module Luminaire C or D: Charge Controller CC G5 is connected to DFLEX Contact your local SIGNIFY employee for further information Recomended luminaire cleaning 6/12... - Page 7 Watch out to the installation date. The battery is 70% level charged when leaving factory. Depending on storage time and ambient temperature, the battery can lose some charge. The labels in the luminaire containe a QR code. For any contact with SIGNIFY regarding the product, please scan the QR code an keep it for reference.
- Page 8 Opbevaring, installation, brug, betjening og vedligeholdelse af produkterne må kun udføres ifølge instruktionerne i denne vejledning og/eller eventuelle øvrige instruktioner fra Signify for at garantere sikker brug af produktet i hele dets levetid. Hvis disse instruktioner ikke følges, bortfalder produktgarantien. Bolte/skruer med angivet spændingsmoment på tegningen skal spændes med en indstillet momentnøgle. Færdigsamlede bolte/skruer skal efterspændes i henhold til det specificerede moment for at sikre maksimal fastgørelse i hele produktets levetid.
- Page 9 Opbevaring, installation, brug, betjening og vedligeholdelse af produkterne må kun udføres ifølge instruktionerne i denne vejledning og/eller eventuelle øvrige instruktioner fra Signify for at garantere sikker brug af produktet i hele dets levetid. Hvis disse instruktioner ikke følges, bortfalder produktgarantien. Bolte/skruer med angivet spændingsmoment på...
- Page 10 10/12...
- Page 11 11/12...
- Page 12 The information presented in this document is not intended as any commercial offer and does not form part of any quotation or contract, unless otherwise agreed by Signify. All trademarks are owned by Signify Holding or their respective owners.