LiftMaster K07-50227 Manuel D'instructions

Life Maseer
INTRODUCTION
This kit is to be used with gate operatormodels CSW200,
csw200U, RSWI 2V, RSW12VDC, RSW12U, csw24V,
CSW24VDC,and CSW24U.
CARTON INVENTORY
1(07- 50227: Outputshaft(with setscrews),Key,Thread Lock
Adhesive
K70-35677: O utput•shaft (with setscrews),Key,
Adhesive,Limit Chain,Limit Cupwith Sprocket,Washer(1-1/8"
wide)
K77-36539:Outputshaft (with set screws), Key,ThreadLock
Adhesive, Limit Chain, Limit Cup with Sprocket,
wide), Limit Sprocket
TOOLS NEEDED
1/4" Allen Wrench
Pliers
Flat head screw driver
Pin Punch
1/2" hardened steel bolt, 2-1/2" or longer
Ratchet or wrench
Mallet
NSTALLATION
REMOVE THE OLD OUTPUT SHAFT
(ALL KITS)
1. Disconnectpowerfrom the operator.
2. Remove the covers and arm assembly from the operator.
3. Rotatethe limit cup to gain accessto the bottom set screwon
the output shaft.
4. Loosenthe set screws on the output shaft with a 1/4"Allen
wrench (force might be requiredto breakfactory installed
thread adhesive).
Removethe output shaft and discard. NOTE:If the output
5.
shaft will not move, insert a 2-1/2" threaded hardened steel
bolt (not provided) into the top of the output shaft. Tighten
the bolt with a wrench to force the shaft free.
6. Removethe keyfrom the gear reducershaft and discard. If
the keywayof the gear reducershaft is damagedin any way,
the gear reducerwill needto be replaced.
REMOVE THE LIMIT CUP ASSEMBL Y
(K77-36539AND K70-35677 ONLY)
Usea pliers and a flatheadscrewdriver(if needed)to remove
1.
the master link from the limit chain.
Remove and discard the limit chain.
2.
3. Removethe limit cup and the washerfrom the reducershaft
and discard.
To preventpossibleSERIOUS INJURYor DEATH, d isconnect
electricpower to operatorBEFORE installing.
ALL installations and electrical connections MUST be made by a
qualified individual.
Thread Lock
Washer(1-1/8"
OutputShaft
Gear Reducer
Shaft
OUTPUT SHAFT REPLACEMENT KIT
K07-50227, K70-35677, AND 1<77-36539
WARNING
Limit Cup
Washer
Cover
Arm Assembly
Set Screws
Limit Chain
Key