Stid ARC1S Notice D'installation

ARC1S – CORE START Mullion Reader
Installation instructions
Product Part Numbers
ARC1SW33BPC37OS1: OSDP™ Raw 40 bits
ARC1SR31BPC33I1: 26-bit Wiegand
Connection
Dimensions
General tolerance following ISO NFT 58-000 standard.
Mounting
- Pass the cables through the hole in the base.
- Screw the base in its final installed location.
- Connect the reader. Test the readings and communication.
- Place the reader on the base (clip the top part and then pivot it down).
- Lock the reader with the two screws provided using the specific tool.
Bus Architecture (RS485)
RT: 120 Ω end-of-line resistor supplied.
R1 & R2: 1.5 kΩ resistors supplied.
Wiring resistors R1 and R2 use extended features
of the RS485 bus: FAIL-SAFE (see RS485AN-960).
TTL Pull-up Wiring
For data signals, 10kΩ pull-up resistors are
connected internally to V (power supply voltage)
in
for optimal wiring distances.
Power Supply Characteristics
Use an AC/DC power supply type LPS, Limited
Power Source (as per IEC/UL/EN 60950-1 Ed2) or
type ES1, PS1 (according to IEC/UL/EN 62368-1) for
the main supply.
Main power supply:
Range: +9 Vdc to +15 Vdc Typical: 12 Vdc
Max. consumption at 12 Vdc:
ARC1S-B/PC3: 150 mA
© STid - 20 PA des Pradeaux FR13850 Gréasque - NI1110D12- Page 1 sur 6 - Ed. 21/08/2025
STid reserves the right to make change without notice, for the purpose of product improvement.
ARC1S - Lecteur étroit CORE START
Notice d'installation
TBLOCK Option
- Press the orange tab to open.
- Insert the wire.
- Release the orange tab.
- Check that the wire is correctly clipped.
Characteristics
Connector output:
8 female stamped crimp terminals 28-22AWG
(Wurth Electronik 62400113722DEC).
8 points female dual-row terminal housing
(Wurth Electronik 624008213322) (use Crimp
Hand Tool WURTH ELEKTRONIK 600624228220).
Protection: IP65 level reader (excluding
connectors)
ARC1S – Lector Estrecho CORE START
Procedimiento de instalación
conforme con NOM-024 -SCFI-2013
More information about
CORE START
TTL Wiegand
4 Brown
5 Red
+Vcc (+9 Vdc to +15 Vdc)
2 Grey
D0
1 Blue
D1
6 Yellow
NC
3
Green
8
Orange
7
White
 Host
Buzzer / LED
Buzzer and LED 1 and 2 are controlled by the
Access Control System with a 0 Vdc respectively on
the "Led 1", "Led 2" and "Buzzer" inputs of the
reader's connector
communication protocol of the reader (OSDP
Type
RS485 OSDP
TM
0 Vdc
NC
L+
L -
Led 1
Led 2
Buzzer
➔ARC1
34,7 mm / 1.37"
or controlled by the
).
TM