Bluetooth - Teac NT-505-X Mode D'emploi

Pairing with another Bluetooth device
Pairing this unit with another Bluetooth device is necessary the first
time it is used and when connecting to a different Bluetooth device
for the first time.
1
Turn the SOURCE knob to select Bluetooth.

Bluetooth

2
Enable Bluetooth transmission on the other
Bluetooth device.
3
Press and hold the SOURCE knob to enter pair-
ing mode.
PAIRING. . .
o "PAIRING..." blinks when pairing.
4
On the other Bluetooth device, select "NT-505-X"
(this unit).
After this unit enters pairing mode, pair with it from the other
Bluetooth device.
For details, refer to the operation manual of that Bluetooth
device.
After connection, the display will show the name of the con-
nected device, followed by the input source.
Display example
CONNECTED TO
iPhone 001
Bluetooth
CHECK
c
VOL. 6
Playback from a Bluetooth device
o Pair this unit the first time you use it and when you want to
connect it with a different Bluetooth device for the first time
(page 19).
o When pairing or connecting with another Bluetooth device,
they should be within a few meters of each other. If they are
too far apart, pairing and connection afterwards might become
impossible.
1
Enable Bluetooth transmission on the other
Bluetooth device.
2
Turn the SOURCE knob to select Bluetooth.
This sets the source to Bluetooth.
o You can also use the Bluetooth button on the remote control.
Display example
Bluetooth
CONNECTED TO
iPhone 001
Bluetooth
This unit will search for paired devices and automatically con-
nect to one if found.
ATTENTION
Depending on the source device, you might also need to con-
duct connection operations on it.
If you are unable to connect it successfully, refer to the opera-
tion manual of the source device.
CHECK
c
c
VOL. 6
EN
19