Makita TM3010C Manuel D'instruction page 5

Adjusting the orbital stroke rate
► 1. Dial
The orbital stroke rate is adjustable. To change the orbital
stroke rate, turn the dial between 1 and 5. The higher the
number is, the higher the orbital stroke rate is. Preset the
dial to the number suitable for your workpiece.
NOTE:
• The dial cannot be turned directly from 1 to 5 or
from 5 to 1. Forcing the dial may damage the tool.
When changing the dial direction, always turn the
dial moving it through each intermediate number.
Constant speed control
Electronic speed control for obtaining constant speed.
Possible to get fine finish, because the orbital stroke
rate is kept constant even under load condition.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing application
tool (optional accessory)
WARNING:
• Do not install application tool upside down.
Installing application tool upside down may dam-
age the tool and cause serious personal injury.
• Install attachment tool in the correct direction
according to your work. Application tool can be
installed at an angle of every 30 degree.
CAUTION:
• Be careful when closing the lock lever. The lock
lever may close suddenly and pinch your finger.
• Clean up dust and perform lubrication on the
moving part of the lock lever from time to time.
Otherwise dust may accumulate in the moving part
of the lock lever and hinder its smooth movement.
• Do not start the tool while the lever opens. The
tool may be damaged.
2
► 1. Holder bolt 2. Lock lever
1
1. Open the lock lever fully. And remove the holder bolt.
► 1. Holder bolt 2. Holes in the application tool
3. Protrusions of the tool flange
2. Put an application tool (optional accessory) on the
tool flange so that the protrusions of the tool flange
fit in the holes in the application tool.
3. Insert the holder bolt till it stops. And then, return
the lock lever to its original position.
When using sanding application tool, mount the appli-
cation tool on the sanding pad so that it matches the
sanding pad direction.
The sanding pad has a hook and loop type fitting system
which allows easy and rapid fitting of a sanding paper.
As sanding papers have holes for dust extraction,
mount a sanding paper so that the holes in a sanding
paper match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
5 ENGLISH
2
3
1
1