Operating Mode; Important - Orion 24795 Manuel D'utilisation

OPERATING MODE

IMPORTANT: Always read the instructions prior to using for the first time.
HANDLING
1 ON/RESET
Press once only to switch on the meter.
Keep pressed to reset the partial meter or the "Trip" to zero.
On/Off
• The meter is probably switched off when you wish to use it.
• Press the ON/RESET button to switch it on (fig. 1). The meter
performs a check on the display by showing all the segments
briefly (fig. 2) and then on the display shows a similar status to
that shown (fig. 3).
• The display shows the partial meter.
• Although switched off, the meter automatically goes to an On
status when detecting fluid flow and starts to record the quantity
released by showing the partial meter.
• In order to save energy the meter switches off automatically after
30 seconds of inactivity. The registered data are stored.
Fig. 1 Fig. 2
Alentec & Orion AB Grustagsvägen 4, SE-13840, Älta, SWEDEN · info@alentec.se · www.alentec.com
2 SELECT
Consecutively press to browse the various functions:
Fluid release
• To release fluid, switch on the meter by pressing the ON/
RESET button or simply start to release and the meter will
automatically switch on by starting to register the fluid.
• If, after successive measurements, (fig. 4) you wish to set (fig. 6)
the partial meter to zero, hold down the ON/RESET button for a
while (fig. 5).
• Each unit of volume released increases both the partial meter
and the total meter.
• When the meter switches off, or the batteries are removed, the
data of the last measurement taken are stored.
Fig. 3 Fig. 4 Fig. 5 Fig. 6
105088
3