Setting Temperature; Thermostat Calibration - Twin Star Home Duraflame 10QI071ARA Manuel D'instruction

OPERATING INSTRUCTIONS CONTROL FUNCTIONS
TO ACCESS CONTROL PANEL-
Control panel can be accessed on the front panel of the heater.
Model#
10QI071ARA
- POWER
1. a. The POWER button supplies power to all the functions of the
heater. Pressing the POWER button again the heater will be
put in standby mode.
b. The POWER button on the control panel needs to be pressed in
order to operate the the remote control.
2. Pressing and holding the POWER button on the control panel for
3 seconds will switch between °F and °C.
- TIMER
1. a. There are 9 timer settings and OFF that can be selected.
OFF(00), 30min, 1Hour, 2H, 3H, 4H, 5H, 6H, 7H, 8H.
b. Double-digit minute settings, such as:
30 minutes are:
c. A digital plus a "H" show hours setting, such as:
2 Hours are:
2. If the timer function was previously set the first press
of the timer button won't change the previous setting.
Pressing the timer button will activate the timer display.
3. When the timer is active, the display will count down from
60 seconds before shutting off the heater.
▲ ▼- SETTING TEMPERATURE
1. When pressing the ▲ ▼ buttons the display will enter temperature
setting mode.
2. When in temperature setting mode pressing the ▲ ▼ buttons will
change the thermostat by 1 °F (1 °C.)
The temperature setting range is between 50 °F - 97 °F
(10 °C and 36 °C).
3. The default temperature is 72 °F (22 °C.)
4. After 10 seconds without control input the display will exit temperature setting mode and show the
current ambient temperature.
NOTE: After the heater function or power is shutoff the blower will continue to run for several minutes to cool
the internal components.

THERMOSTAT CALIBRATION

Thermostat readings can vary based on the running environment. If desired the thermostat on the heater can be
manually calibrated. To calibrate the thermostat:
1. Press the TIMER button for 3 seconds to begin calibration.
2. Use the ▲ ▼ buttons to adjust the thermostat. The calibration range is -9°F to 9°F (-5°C to 5°C).
3. After 10 seconds without control input the heater will exit thermostat calibration.
Figure 4
E-5
Figure 5
NOTE: PLEASE OPERATE REMOTE
TRANSMITTER AT A SLOW MEASURED
PACE. PRESS THE REMOTE CONTROL
BUTTONS WITH AN EVEN MOTION
AND GENTLE PRESSURE. REPEATEDLY
PRESSING BUTTONS IN RAPID
SUCCESSION MAY CAUSE THE
TRANSMITTER TO MALFUNCTION.