Lorell LLR52510 Manuel D'instructions

Instruction Manual
PARTS & QUANTITY
PARTS
Phillips Screws
(for tray)
Wall Brackets
Drywall Anchors
Phillips Screws
(for mounting)
Phillips Head Tip
SECURING PEN TRAY
Back of Board
Slide
Of Pen Tray
MOUNTING INSTRUCTIONS
1.
Determine the position you want to mount the board.
Draw a line for top and bottom perimeter.
2.
Measure up 40mm above the bottom line of board,
and fix two hangers by anchor and screw.
140m m
LLR25210 LLR25211 LLR25212
2pcs 2pcs 3pcs
4pcs 4pcs 4pcs
4pcs 4pcs 4pcs
4pcs 4pcs 4pcs
Ipc Ipc Ipc
to BOARD FRAME
1. Position
2. Place screws into board rail where the pre-drilled
on the pen tray. Tighten with phillips head tip.
3. Check results. If not satisfied, start over from the beginning.
pen Tray
To Center
Manufactured
LLR52510/52511/52512/52513
LLR25313
4pcs
4pcs
4pcs
4pcs
Frame with foam bar to accept push pin.
Ipc
Pen Tray at desired location along board rail.
3.
Measure down 20mm from the top line of board, and
fix two hangers by anchor and screw.
4.
Put your board into bottom hangers, and push down
top hangers to hold the board.
in China for S.P. Richards Co., Atlanta,
Dry Erase Board
FOAM BAR
holes are
20 mm
push down
GA
+