Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Trouble Shooting
If there is no sound from your speakers, check these settings on the C2P Master Speaker
• Make sure a signal source is connected and producing sound
• Make sure the white power ON LED is illuminated on the front of the speaker.
• Confirm the included power supply is connected and the power switch is set to the ON position.
• Make sure the volume control is not set to the full counter clockwise position
• If the C2P Extension Speaker does not produce sound, make sure the extension speaker wire 1/4" plug is
connected to the EXTENSION SPEAKER 1/4" output connector. Make sure the bare-wire end of the cable is
connected to the extension speaker wire terminals.
• If the system sounds as if it lacks low frequency (bass) performance, confirm the bare wire is connected so
the RED wire is connected to the RED speaker wire terminal, and the other wire is connected to the
BLACK speaker wire terminal.
If the above measures do not correct the problem, please contact JBL Professional
NOTE: If the red LED on the front of the speaker flashes due to continuous over-driving of the system, overload-protection may be
activated and no sound will be heard. To resume operation, reduce system volume, turn the power switch OFF and then ON again.
Specifications
Frequency Response (+/- 3dB):
Frequency Range (-10dB):
Maximum Peak SPL
C2PM Master Only
Maximum Peak SPL Per-Pair
LF Transducer:
HF Transducer:
Overload Protection:
Crossover Frequency:
Signal Input Connectors (x2):
Input Sensitivity:
Amplifier Power:
Power Requirements:
Headphone Jack:
Enclosure Material:
Finish:
Dimensions (H x W x D):
Net Weight Master Speaker:
Net Weight Extension Speaker:
Shipping Weight per Pair:
Optional Accessories:
1
IEC Pink Noise at 1 meter.
2
Neutrik and the names of Neutrik products referenced herein are either trademarks and/or service marks of Neutrik.
3
CAUTION
: Unsafe mounting or overhead suspension of any heavy load can result in serious injury and equipment damage. Mounting of speakers
should be done by qualified persons in accordance with all applicable local safety and construction standards. Be certain to follow the instructions
provided by the manufacturer of the mounting bracket. Before selecting a mounting bracket, be certain that it is capable of supporting the weight of the
speaker to be mounted.
6
100 Hz – 18 kHz
80 Hz - 20 kHz
1
:
111 dB (1)
1
:
115 dB (1)
135 mm (5.25 in) low frequency loudspeaker
19 mm (.75 in) polycarbonate dome tweeter
Internal Peak Limiter and Overload Protection
4.2 kHz
Balanced Neutrik
+4 dBu XLR / 1/4"; 0 dBu RCA
35 Watts continuous per-channel
19 VDC / 3.42 A - use only supplied power supply
3.5 mm (1/8")
Polypropylene Structural Foam
Black
235 x 159 x 143 mm (9.3 x 6.3 x 5.6 in)
2.6 kg (5.5 lb)
2.2 kg (4.5 lb)
12.5 lb / 5.8 Kg
MTC-2P Mounting Kit
2
®
Combo XLR 1/4" TRS; Unbalanced RCA
3
:
Publicité
Table des Matières
