Joka JID900 Manuel D'utilisation page 16

THE PICTURES BELOW INTEND TO MAKE YOU FAMILAR WITH DIFFERENT FUNCTIONS OF YOUR IMPACT DRILL.
THESE PICTURES MAY NOT SHOW THE ACTUAL IMPACT DRILL MODEL THAT YOU HAVE PURCHASED. BEFORE
ANY INTERVENTION, YOUR IMPACT DRILL MUST BE UNPLUGED FROM THE POWER SOURCE.
COUNTER-CLOCKWISE
CLOCKWISE
CHUCK KEY
FIG. 1
SIDE HANDLE
FIG. 2
FIG. 3
FIG. 4
IMPACT DRILL IN OPERATION
ASSEMBLY
1. INSERTING OR REMOVING THE DRILL
PLACE THE CHUCK KEY IN 1 OF THE 3 HOLES LOCATED ON THE
CHUCK. LOOSEN THE CHUCK JAWS BY USING THE CHUCK KEY.
INSERT THE DRILL INSIDE THE CHUCK. TIGHTEN THE CHUCK IN
CLOCK-WISE DIRECTION (FIG. 1).
TO REMOVE THE DRILL, LOOSEN THE CHUCK IN COUNTER-
CLOCKWISE DIRECTION.
2. INSTALLING OR REMOVING THE SIDE HANDLE
3. INSTALLING THE DEPTH GUIDE
THE DEPTH GUIDE IS CONVENIENT FOR DRILLING HOLES OF UNIFORM
DEPTH. LOOSEN THE SIDE HANDLE AND INSERT THE DEPTH GUIDE
INTO THE HOLE IN THE SIDE HANDLE. ADJUST THE DEPTH GUIDE TO
THE DESIRED DEPTH AND TIGHTEN THE SIDE HANDLE (FIG. 3)
4. REPLACING THE CARBON BRUSHES
TO MAINTAIN THE PEAK EFFICIENCY OF YOUR POWER TOOL MOTOR,
WE RECOMMEND THAT THE CARBON BRUSHES BE EXAMINED EVERY
2-6 MONTHS. AS THE CARBON BURSHE IS AN INTERNAL PART YOUR
POWER TOOL, THE SERVICE MUST BE PERFORMED BY QUALITIED
PERSONNEL
5. REMOVING OR INSTALLING THE CHUCK
TO REMOVE THE CHUCK, LOOSEN THE CHUCK JAWS AND REMOVE
THE THREAD SCREW LOCATED INSIDE THE CHUCK WITH A
16/28
THE S IDE HANDL E PROVID ES ADDITIONAL CONTROL AND SU PPORT F OR THE IMP ACT DRI LL. THI S HANDL E I S AD JUST AB LE 3 60 AR OUND ITS ROT ATI ON A XIS
°
(FIG. 2).