Nilfisk GU 350 A Mode D'emploi page 3

DOUBLE-INSULATED MACHINES
IMPORTANT
240 volt 50 Hz. machines are fitted with a 13 amp. 3 pin moulded plug.
the plug is fitted with a 10 amp. detachable fuse. The correct
replacement for the fuse is identified by marking or colour coding.
Only fuses that are ASTA approved to BS 1362 should be fitted.
Never use the plug without the fuse cover fitted. Replacement fuse
covers are available at any electrical retail outlet.
If the available socket outlet is not suitable for the plug supplied, the
plug must be cut off and an appropriate plug fitted. The plug thus cut
off MUST BE DESTROYED for safety reasons before being dispo-
sed of.
Machines built for other voltages and frequencies are not normally
supplied with a fitted plug.
If it is necessary to fit a plug, the wires in this power supply cord are
coloured in accordance with the following code:
BLUE-NEUTRAL
BROWN-LIVE
TO CONNECT THE NEW PLUG:
If using a three-pin plug, do not make any connection to the the
terminal in the plug which is marked with the letter 'E' or by the safety
earth symbol or coloured green or green & yellow. This machine is
double-insulated and no earth connection is necessary.
The wire which is coloured blue must be connected to the terminal
in the plug which is marked with the letter 'N' or is coloured black or
blue.
The wire which is coloured brown must be connected to the terminal
in the plug which is marked with the letter 'L' or is coloured red or
brown.
If the plug to be fitted does not conform to the above notation then
consult a qualified electrician.