Tangent EVO BT-30 Mode D'emploi page 8

Bluetooth Speaker can pair with most Bluetooth 2.0 & 2.1 devices. Pairing may vary by device.
Consult your Bluetooth device's owner's manual for pairing instructions.
1. Press "Standby" key to switch on the unit
2. Select [Blue-tooth] key with the remote control. The LED light will go Super white.
3. Press and hold "PAIR" key for 3 seconds until consecutive "beep" sound is played, the
Bluetooth Super White LED would flashing to wait for your Blue-tooth device pairing.
4. Turn ON your Blue-tooth device (e.g. Smart Phone) setting, "BT" would be shown at your
device Blue-tooth list.
5. Connect your device to the BT Speaker with Blue-tooth, your device menu would show
"Connected", the Bluetooth LED would keep ON at Super white when pairing success.
6. You can play your music wirelessly with the BT Speaker.
Remark:
For mobile with Bluetooth 2.0, its request to enter pass code during pairing, press 0000
The BT speaker can remember up to 8 Blue-tooth devices, to clear the memory, press
"Play/Pause" and "Pair" key at the same time until a "Beep" sound come out.
After memory clear, the unit would go to pairing mode, you need to do the pair step with your
phone again.
*Operating range of Bluetooth audio is
structures may affect range of device.)
Auxiliary Audio Operation
1. Connect a media player to the aux-in jack on the back panel of the unit.
2. Select [Aux] key with the remote control. The LED light will go Dusky white.
3. Adjust the volume to fit your need.
4. In Aux mode, operate your audio device directly for playback features.
Adjusting Sound Effect
Press the POP, JAZZ, ROCK, CLASSIC or FLAT buttons on the remote control to select desired
music mode.
 Connected with power adaptor with Speaker DC in jack
 Plug one end of the USB cable at the back of your unit, plug the other end of the USB
cable into a USB port on your other devices to made for USB charging.
1. If the system does not work as expected, first carefully read this manual.
2. No operation: Check power adaptor and that mains power has been turned on.
3. If still not successful, contact your TANGENT customer support.
up to 10 meters. (Measured in open space. Walls and
Charging other devices
Troubleshooting and Support