Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
CARBON MONOXIDE (CO) DETECTOR
GENERAL INFORMATION
IMPORTANT:
> These instructions contain important information about the correct installation and
operation of the CO detector. Read the entire manual carefully before proceeding with
the installation.
> The installation of this device must be carried out properly by specialized technical
personnel.
> In case of improper use of the device, the warranty shall be void and the manufacturer
declines all responsibility for damage to persons or property.
> This detector is designed to protect people from the acute effects caused by carbon
monoxide exposure. It does not completely protect people with particular pathologies.
If you have any queries, eek medical advice.
> The device cannot prevent the chronic effects due to CO exposure.
> The device does not work as a substitute for smoke detectors or gas detectors.
The BMTCO
monoxide in the air.
Carbon monoxide (CO) is a poisonous gas that is released from the combustion of any fossil fuel such
as wood, coal, oil, natural gas, fuel oils, propane, butane, gasoline, diesel, etc.
It is an odourless, colourless and non-irritating gas that can escape from pipes, cooking and heating
appliances that are not kept in perfect working order or
I
n the human body, "CO" binds to the blood haemoglobin and reduces the oxygen supply: n high
concentrations, it can kill in a few minutes.
OPERATION
To turn the detector on,
A
t the start
the device checks the correct opration of
the red LED, the green LED and the buzzer.
T
hen the heating phase of the sensor is activated
lasts about 60 seconds signalled by the green LED
" ef. "
R
2 turning on.
Once the heating phase has finished, the sensor is
ready for use: this condition is indicated by the
flashing of the green LED
seconds).
When the gas concentration exceeds the expected
threshold, it triggers the sound alarm (buzzer with
intermittent sound) and visual alarm (1 flash of red
LED
" ef. "
R
3
every 2 seconds).
8
"
" detector, specifically
press
the switch
" ef. 1"
R
" ef. "
R
2
(1 flash every 2
s
designed
for the
RV
.
The alarm remains activated until the detector is
turned off or the "CO" level returns to normal.
and
sector, is able to detect the presence of carbon
that are faulty
.
1
2
i
3
Publicité
Table des Matières
