Techfrost SG30 Mode D'emploi page 22

POS.
Programming key "+" and "-"
SET POINT and PROGRAMMING
Combination to "LOCK KEYPAD"
+
+
"PROGRAMMING" mode
Customer parameters menu
+
WARNING!
TECHFROST
DESCRIPTION
display key
DEFROST START key
DEFROST LED
COMPRESSOR LED
Combination to enter
Overcooling cycle start
High / Low Humidity
DO NOT USE ELECTRICAL APPLIANCES INSIDE THE FREEZER
FUNCTION
In the programming mode, used to scroll the
parameter codes or increase their value
In the programming mode, used to scroll the
parameter codes or decrease their value
To display or change the SET POINT. In the
programming mode, used to select a parameter or
confirm a value
Used to start the DEFROST function (press on the
symbol)
Two possible status displays:
• ON – Defrost in progress
• INTERMITTENT – Programming mode (alternates
with COMPRESSOR LED) or dripping in progress
Two possible status displays:
• ON – Compressor in operation
• INTERMITTENT – Programming mode (alternates
with DEFROST LED) or delay between
successive starts in progress
Press both keys simultaneously to activate the
described mode, "Loc". Same procedure applies for
release, shown as "UnL".
Press both keys simultaneously to enter the described
mode
Press the key for 3 sec. to enter the customer
parameters menu.
Press the key for 3 sec. to activate the described
mode.
The appliance can operate with two different humidity
thresholds. To select the highest level, press the keys
+ for 3 sec. The readout rhH appears on
the display and the fan operates continuously. Use the
same procedure to set low humidity; readout rhL.
COMPARTMENTS
Pagina 21 di 47