Publicité
Les langues disponibles
Les langues disponibles
Table 3
Chain dimensions
Max. load tonnes
Model
Link diameter nominal mm
Link diameter min. mm
Pitch dimension (5xP) nominal mm
Pitch dimension (5xP) max. mm
The chain must be discarded and replaced if:
•
cracks are detected on any link
•
any link is deformed or otherwise damaged
•
The minimum value of any link's diameter falls short
•
the maximum value of the pitch dimension is exceeded at any point
•
the chain is damaged by overheating or has been affected by weld splatter
Chains must not be repaired – they must be replaced by a new original chain. If it is desired to lengthen the chain, it must be replaced by a new
and longer chain.
Replacement of the chain shall be performed professionally by an authorized repairer and the chain must meet the requirements stated in the
standard EN 818-7, Grade T from the following manufacturers: Chaineries Limousines, Pewag, Thiele or Rud.
Repairs
The lever hoist must not be modified. Repairs must be carried out by specialists. Damaged parts must only be replaced with original Powertex
spare parts. Order them through your dealer.
Declaration of conformity
SCM Citra OY
Asessorinkatu 3-7
20780 Kaarina, Finland
www.powertex-products.com
hereby declares that the POWERTEX product as described above is in compliance with EC Machinery Directive 2006/42/EC & EN 13157.
0,25
0,5
0,8
PLH-S2
PLH-S2
PLH-S2
4,0
5,0
5,6
3,6
4,5
5,0
60,0
75,0
85,0
61,8
77,2
92,7
5
1,6
3,2
PLH-S2
PLH-S2
PLH-S2
7,1
10,0
10,0
6,4
9,0
105,0
140,0
140,0
108,1
144,2
144,2
6,3
9
PLH-S2
10,0
9,0
9,0
140,0
144,2
Publicité
