aidapt VM701 Instructions D'utilisation Et D'entretien page 2

VM7 1 Aidapt Lotion Applicator
INTRODUCTION
Thank you for deciding to purchase the Lotion Applicator from Aidapt.
NB. A RISK ASSESSMENT SHOULD BE UNDERTAKEN AS TO THE SUITABILITY OF THE
PRODUCT FOR THE PARTICULAR USAGE.
BEFORE USE
Carefully remove all packaging. Avoid using any knives of other sharp instruments as this may damage
the surface of the product.
Check the product for any visible damage if you see any damage or suspect a fault, do not use your
product, but contact your supplier for support.
INTENDED USE
This Lotion Applicator from Aidapt is designed to aid and assist in the application of creams and lotions
in hard to reach areas such as shoulders and backs.
INSTRUCTIONS FOR USE
Unscrew the round applicator head containing the roller balls. Squeeze your cream/lotion into the round
tray. Do not overfill. Screw applicator lid back on ensuring it is closed tightly. Grip the Lotion Applicator
with the ergonomically designed handle in either hand. When you are ready massage the round roller
balls onto desired area of skin. Lotions/creams will be dispensed from the applicator head evenly.
CLEANING
Unscrew applicator head and clean using a non¬abrasive cleaner or mild detergent with a soft cloth.
Abrasive cleaners e.g. AJAX and/ or abrasive cleaning pads may damage the product beyond repair
and should not be used.
Always ensure that you wipe dry the equipment after cleaning.
REISSUE
If you reissue or are about to reissue this product, please thoroughly check all components
for their safety.
If in any doubt, please do not issue or use, but immediately contact your supplier for service support.
CARE & MAINTENANCE
Please make a safety check of the product at regular intervals or if you have any concerns.
IMPORTANT INFORMATION
Please exercise common sense and do not take any unnecessary risks when using this product; as the
user you must accept liability for safety when using the product.
Please do not hesitate to contact the person who issued this product to you or the manufacturer (detailed
below) if you have any queries concerning the assembly/use of your product.
2