Kit Part No/No
de piöce:
H461 SXCIOI
SUBARU
FORESTER
Kit Part No/No
de
H461SXC101
INTERIOR
FOOTWELL
ILLUMINATION
ÉCLAIRAGE DE L'ESPACE POUR LESPIEDS
Fi 13399
Page
1 of/de
11
Issue/ Version: 1.7 Date: Aug. 27, 2019
O Lumen
North America
2019
Table des Matières
loading

Sommaire des Matières pour Subaru H461SXC101

  • Page 1 Kit Part No/No de piöce: H461 SXCIOI SUBARU FORESTER Kit Part No/No H461SXC101 INTERIOR FOOTWELL ILLUMINATION ÉCLAIRAGE DE L'ESPACE POUR LESPIEDS Fi 13399 Page 1 of/de Issue/ Version: 1.7 Date: Aug. 27, 2019 O Lumen North America 2019...
  • Page 2: Remarques Générales

    Kit Part No/No de piöce: H461 SXCIOI SUBARU General Notes • Read through the fitting instructions before installation of the accessory. Install the accessory following the fitting instructions. Failure to do so may cause damage to the vehicle or the accessory.
  • Page 3: Parts Supplied

    Kit Part No/No de piöce: H461SXClOl SUBARU Parts Supplied fournies Light x2 Cable Tie x7 Hamess Foam Tape Large xl Foam Tape - Small x2 Bracket Appareil déclairage Ruban mousse - Large xl Support x Faisceau Attaches Ruban mousse - étroit...
  • Page 4: I Schéma De Cäblage

    Kit Part No/No de piöce: H461 SXCIOI SUBARU Wiring outline I Schéma de cäblage Harness / Faisceau Light / Appareil d'éclairage Fi 13399 Page 4 of/de Issue/ Version: 1.7 Date: Aug. 27, 2019 O Lumen North America 2019...
  • Page 5 Kit Part No/No de piöce: H461 SXCIOI SUBARU Step 1 1Étape 1 Move Seats to Rear most location. Déplacez Ie siöge complötement vers l'arriöre. • Step 2 1Étape 2 • Disconnect the negative battery terminal. Débranchez la borne négative de la batterie.
  • Page 6 Kit Part No/No de piöce: H461 SXCIOI SUBARU Step 4 1Étape 4 • Remove lower trim panel (3) clips. • Retirez les attaches du panneau de garniture (3) inférieur. step 5 1Étape 5 • Remove the seven phillips head screws@ .
  • Page 7 Kit Part No/No de piöce: H461 SXCIOI SUBARU step 7 1Étape 7 • Remove rubber boots@from airbag mounting Studs on LH (drivers side). • Retirez les soufflets en caoutchouc O des tiges de montage du coussin gonflable du cöté gauche (cöté...
  • Page 8 Kit Part No/No de piöce: H461 SXCIOI SUBARU Step 10 1Étape 10 • Secure the harness O on the LH side with the three wire ties @ to factory ignition harness at the white tape marks@ and the green tape mark@ of illumination harness as shown.
  • Page 9 Kit Part No/No de piöce: H461 SXCIOI SUBARU step 13 1Étape 13 • Plug in long side of harness O to LED@. • Mount LED@to glove box inner frame@. • Re-lnstall glove box inner frame. • Branchez Ie cöté long du faisceauO au bottier d DEL@.
  • Page 10 Kit Part No/No de piöce: H461 SXCIOI SUBARU Step 16 1Étape 16 Connect power plugO to factory Illumination Control harness@. • Wrap the connectors in the large foam O. • Wrap factory Illumination Control harness @ in the small foam@.
  • Page 11 Kit Part No/No de piöce: H461SXClOl SUBARU Wiring Diagram I Schéma de cäblage Vehicle / Véhicule Vehicle / Véhicule ILL + ILL CONT ILL - CONTACT I_QEL] I_QELI Accessory - Footwel Ilumination Accessoire éc airage de l'espace pour les pieds E.

Table des Matières