Lorell 99955 Manuel D'instructions

Instruction Manual
1. Before beginning the assembly process, carefully pull all excess cord out through the bottom of the lamp base.
Continue pulling the cord until the upper section of the lamp is lined up with the bottom section and no excess
cord is visible.
2. Carefully remove all pieces from the packaging.
Screw the upper part of the arm (B) into the connector
3.
Screw the lower part of the arm (B) tightly into the threaded stem (C) on the lamp base and rotate to tighten.
4.
5. Install the IOW LED Bulb (D) into the socket of the lamp holder and screw it tightly in.
6. If necessary, turn the nut (F) and tighten.
7. Plug into wall outlet.
Turn the lamp on with the chain switch (E) conveniently
8.
CARE AND MAINTENANCE:
Always ensure the product is unplugged from the electrical
disassembling, relocating, servicing, or cleaning it. Clean the product with a soft cloth; do not use liquids,
abrasive cleaners, or solvents.
BULB REPLACEMENT:
1. Ensure the product is unplugged and cool to the touch before proceeding.
2. Remove the IOW LED
3. Replace old bulb with new IOW LED bulb.
WARNING: Use low LED
bulb from the socket.
bulb or smaller.
F
D
Manufactured
Remove the IOW LED Bulb from its box.
on the shade (A) and rotate to tighten.
located on the shade of the lamp.
outlet and allowed to cool before assembling,
B
Pull Excess
in China for S.P. Richards Co., Atlanta, GA
15" LED Bankers Lamp
Cord
99955