Mopar 8223703 Instructions D'installation

amopar
ACCESSORIES
Please read instructions
thoroughly before starting.
GRAND CHEROKEE
Clean and degrease rearfascia where the Splashguards are to be located.
I.
Identify trim line on passenger's side side part and remove corner for tail pipe
2.
clearance
Identify and remove fascia edge plastic inset (see diagram).
3,
Holding liner out, install spring clip over existing hole, Reposition liner and install screw.
4.
Position Splashguard making sure bottom is parallel to road surface and
5.
coverage
Mark screw location by tapping Splashguard with a small
6.
hammer at each location. Drill 3/32' (2 mm) pilot holes through Splashguard and fascia
edge for remaining
Remove part, enlarge marked and drilled pilot holes to 3/16"
7.
(5 mm)v (Enlarged holes will not strip wax coating off screws).
Removepreviouslyinstalledclip screws.RepositionSplashguardand installall screwsr Do
8.
not over tighten.
P/N 8223703
REAR
holes, Use all screws provided,
SPRING CUP
FENDER
LINER
SCREW
Installcip with turnedup edgeon insideat tenderlinet
SPLASH
INSTALLATION
Tools Required: •
•
• Clean Cloth/Rag
Hardware
Qty Description
L. H. Splashguard
I
R. H. splashguard
# 8 Screws (Wax Coated)
6
# 10 Screws
2
# 10 Spring Clips
2
Instruction
1
REAR
PANEL
SPLASHGUARD
TIRE
GUARD
INSTRUCTIONS
#2 Phillips Screwdriver
3/32', 3/16" Drill bits
Drill
Required:
Sheet
tire
86370 7/97