OTC StrutTamer II 6582 Instructions De Montage

Parts
Item part
No. No. Qty.
1 527697 8
2
218920 2
3 223328 1
4 526433 1
5 527573 2
6 527698 2
7 205727 2
8 212336 4
9
223270 4
10 527700 4
11 527699 4
Install tray offset to back
of stand and flush with
front of frame.
Use top two holes in
StrutTamer II body to
mount StrutTamer II on
stand.
655 Eisenhower Drive
Owatonna, MN 55060 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (800) 533-6127
Fax: (800) 283-8665
Intemational Sales: (507) 455-7223
Fax: (507) 455-7063
StrutTamer II Stand
(designed for OTC StrutTamer No. 6580, 6591, 6637)
List
Description
Hex Locknut (M12 x 1.75)
Hex Hd. Cap Screw
Tool Tray
Decal
Flex Grip Handle
Hex Hd. Cap Screw
(M12x 1.75 x 120)
Wheel (4' dia.)
Cap Screw
Rubber Bumper
Hex Nut (1/4-20 UNC)
Machine Screw
1.Insertmachinescrews(11) throughrubberbumpers(9),andusehexnuts(10)
to attach rubber bumpers to legs.
2.Attachlegstocrossmemberusingcapscrews(8)andhexlocknuts (1). Usecap
screws (8) and locknuts (1) to attach wheels (7) to legs.
3. Position vertical frame between tangs in cross member, with StrutTamer II
mountingholestowardfront of stand as shown.Use capscrews(6) and locknuts
(1) to attach frame to tangs.
4. There are three pairs of mounting holes which may be used to mount the
StrutTamerIIto themobilestand. Selectone pairwhichwould holdtheStrutTamer
II at the desiredheightafterassembly.Usecap screws(2) andlocknuts(1) to
vertical
frame assemble
5. The tool tray (3) is designed to be offset to the back of the stand, and flush with
the front of the frame, so it doesn't interfere with the StrutTamer II. Install tool
tray by pushing mounting tangs into frame.
cross
member
e
0
leg
Parts List &
Assembly Instructions
for:
9, 10, 11
Assembly
(Item numbers refer to the parts list.)
StrutTamer II to stand.
Form No.
1
Instructions
Rev. C, December
O Bosch Automotive Service
520561
6582
3
5
4
7
8
Sheet 1 of 1
21.2017
Solutions Inc.