Hubbell HBL985 Instructions D'installation

GANGABLE
CAUTION: RISKOF ELECTRICAL S HOCK.Disconnect power before installing or servicing.
NOTICE: For installation by a qualified electrician in accordance with all national and local electrical codes,
communications standards, the following instructions and any instructions included with individual devices.
NOTICE: Insure data/communications circuits are separated from lighting/power circuits in accordance with the NEC@
and CECode requirements.
If installing a 2 or 3 gang box, go to step 5.
1.
For installations requiring more than 3 gangs, remove screws [1]
2.
and side [2] from one end of the box.
Install 3 gang [3] or 2 gang [4] center sections as needed using
3.
screws provided. Center sections can be installed with 2 inch trade
KOsoriented up or down.
Reinstall box side to end of center section with screws provided.
4.
Position mounting brackets [5] on box sides. Position brackets for
5.
proper finished wall thickness, aligning the bracket edge with
marking. Secure brackets to box sides using screws provided.
6. Attach far wall support [6] to side bracket and secure with screw.
Position of far wall support is based on stud bay depth. Do not use
far wall support for 3-1/2" stud bays.
Torque all screws to 10 - 15 lbs-in torque [1.1 - 1.7 N•m].
7.
Remove knockouts as needed for wiring connections.
8.
any unused openings.
9. Install voltage partition [7], HBL989(sold separately), if needed.
Torque mounting screwto 10 - 15 lbs-in torque [1.1-1.7
10. Mount box to stud using appropriate fasteners, not provided.
11. Complete wiring per local codes.
PI-)2626 09/14
WALLBOX - Installation
Do not leave
7
5
6
Instructions
1
00
2
N•m].
CatalogNo.
HBL985
HBL986
HBL987
HBL988
ENGLISH
3
4
3
Gangs
Total Volume
54 [884 cm3]
2
79 ins [1293 cm3]
3
104 ins [1702 cm3]
4
154 ins [2520 cm3]
6
HUBBELL