Important - DOMUS LINE MAGIC TUNE TW Manuel D'installation

INSTALLATION MANUAL
TECHNICAL DATA:
Power supply: 24Vdc
FOR RECEIVER CONTROLLER TW:
Max power: 60Watt
: Remote control range 15 meters.
FOR REMOTE CONTROL TW
Battery type used: CR2032 (3V) lithium.
WARNINGS
Safety is guaranteed if these instructions are followed and therefore they
must be kept. Installation may require qualified personnel to be
involved. Before proceeding with installation of the device ensure that
the environmental conditions are in compliance with and suitable for the
product characteristics. Before any operation on the device remove
mains power.
INSTALLATION:
- Fix the support bracket (8) (fig.1) using the screws (9) supplied or a
double-sided tape (7).
- Insert the battery in the remote control (10) as shown in fig.2.
PROGRAMMING THE RECEIVER Fig.4
(maximum 7 transmitters with one receiver):
- Connect the receiver to the converter (not supplied in the package) as
shown in fig.4.
- Connect the luminaires.
CAUTION: do not connect any luminaire directly to the connector of the
receiver, but always use the voltage distributor 11 supplied in the
package.
- Connect the power plug to the power supply, the blue LED (2) flashes.
- Briefly press the button (2) on the receiver.
- The blue LED (2) will remain lit for 60 sec. by which the programming
operation must be completed, holding down for more than 5 sec. the
power button (3) on the transmitter (1). The blue LED (2) turns off
confirming the correct programming of the system.
It is possible to control multiple receivers with a single transmitter,
programming them as indicated in fig.5
EN
OPERATION (fig. 6):
- Key 3 = ON/OFF
- Key 4 = Increase the brightness
- Key 5 = Decrease the brightness
- Switch 6 = Light colour temperature adjustment
RECEIVER PROGRAMMING RESET (fig.7):
It is possible to cancel the programming of the transmitters paired with
the receiver proceeding as follows:
- Press button (2) briefly, the blue LED flashes once.
- Press button (2) in quick succession three times; the LED flashes twice;
at this point the receiver is completely reset.
WARNING:
After 60 sec. of inactivity, the control system goes in "STAND-BY" mode,
during which it is not possible to make any adjustments until one of the
buttons on the transmitter (1) is pressed.
BATTERY-POWERED DEVICES:
Dispose of batteries according to local regulations. Some batteries can
be recycled and it can be possible to dispose of them at the local
recycling center. If it is not possible to find the applicable regulations in
your area, check the instructions of the battery manufacturer.

IMPORTANT:

The installation must be performed by qualified personnel following the
instructions attached and those in fig.3
WARRANTY
The warranty on the device is valid only if powered by a power supply
provided by DOMUS Line. The warranty general terms and conditions
for this device are available at www.domusline.com