Ashley Furniture D480-80 Instructions De Montage

THE WORLD CLASS
BLY ASSEM INSTRUC TION
IMPORTANT S AFETYNOTICE:READCAREFULLY BEFOREBEGINNING ASSEMBLY!
* Always use proper tools.
* Follow the assembly steps in order.
* Carefully review the list of parts.
from which you purchased the product
USE SUBSTITUTE PARTS.
* Periodically check to ensure that all connectors (bolts, screws, etc.) are tight.
* Keep the instructions for future reference.
* Some assembly may involve attaching
handling the glass or mirrors, as severe injury
mirror breaks. Never handle large pieces of glass or mirrors
NOTE: ASHLEY FURNITURE
FAILURE TO PROPERLY
CHECK TO SEE THAT THE FOLLOWING PARTS ARE IN THE HARDWARE PACK!
NODRAWING Q'
A PHILLIPS HEAD
SCREWDRIVER IS
NEEDED FOR
ASSEMBLY
*NOT INCLUDED*
NOTE: UNIT SHOULD BE ASSEMBLED BY TWO OR MORE PEOPLE.
DO NOT TIGHTEN ANY BOLTS UNTIL ALL BOLTS HAVE BEEN STARTED!
Leg
Tipping Restraint
Stack—em
Plate
Leveler
O Ashley Furniture
FURNITURE INDUSTRIES
FURNITURE
SHEE T
DO not skip any steps.
If parts are missing, contact the retailer
to obtain any missing parts. DO NOT
glass or mirrors. Be very careful
may result if the glass or
by yourself.
INDUSTRIES, INC. DISCLAIMS ANY LIABILITY FOR DAMAGES OR INJURIES
FOLLOW ASSEMBLY INSTRUCTIONS,
DESCRIPTION
51 LOCK WASHER
T WASH R
1. Lay the
on a smooth
2. Carefully
as shown.
3. Secure
lock washer
Repeat
4.
5. Tighten
6. Carefully
Shelf Support
Industries, Inc., August
INC.
COMPANY@
FORD480-80/81
* When assembling products that have electric cords (lamps, lights, etc.),
always (1) make sure the electrical cord is unplugged before assembly and (2)
be careful not to twist the electrical
* When assembling shelves
shelves in order to assemble
* Do not stand on tables, including
tables, and dinner tables, as tables
person.
* Where assembly instructions
dQ—nQ.kattempt assembly by yourself
PROPERLY ASSEMBLE THE PRODUCT,
NODRAWING Q'
2
2
base on its back
and protective
insert the leg into
the leg in place by turning
B and flat washer
for the remaining
all bolts using the
set the base upright.
1. Carefully place
2. Rotate the
them to the back
with screws F
3. Open the top
shelf supports
side.
4. Carefully place
E
the supports.
NOTE: IF THE
A LEVELER UNDERNEATH
THE UNIT IS LEVEL.
PROTRUDING SEGMENTS.
! WARNING !
The use of the
may reduce, but
of furniture tip
instructions on the
installation.
2008. All Rights Reserved.
cord during assembly.
or entertainment centers, do not stand on lower
upper shelves—use a step ladder.
but not limited to, end tables,
are not meant to support the weight of a
state that assembly requires two or more
as there is a risk of injury.
WHICH MAY OCCUR DUE TO
OR PROPERLY USE THE PRODUCT.
DESCRIPTION
SHELF SUPPORT
5 16 x 16mm RW
L ELER
TIPPING IN
or place it upside
surface.
the corner of the
an Allen
C into each hole.
legs.
Allen wrench D.
the top onto the
stak—em plates and
of the top and
as shown.
doors and insert
E into the holes in each
the glass shelves
UNIT IS NOT LEVEL,
ONE FOOT
BREAK OFF ANY
included tipping
not eliminate, the
over. Follow the
plastic bag for
I of I
coffee
people,
down
base
bolt A,
base.
fasten
base
the
onto
PLACE
UNTIL
restraint
risk
proper