EGLO 203992A Guide De L'utilisateur

21EGL0
PACKAGE CONTENTS
Mounting bar
PLANNING INSTALLATION
d Rea allinstruction s before a ssembly. Before s tarting i nstallation ofthis fixture o rremoval ofa previous fixture, disconnect the power b yturning o ff
the circuit breaker orbyremoving thefuse atthefuse box. T oavoid damaging
carpet or cardboard.
INSTALLATION
I. Unscrewcap nuts (EE)from mountingbar (AA). Save
for later use. Separate the mounting bar (AA) from lamp
body (A).
2. Use electricdrill (not included)to drill two holes on wall then
pushtwowall anchors(BB)intowall.Fastenmounting bar
(AA)to outletboxusingtwowoodscrews(CC).
cc
Wood
Wall Anchor
c
Wire Connector
Screw
thisproduct, assemble itonasoft, n on-abrasive
3. Strip3/4in. of insulation fromfixturewireends.Twiststripped
endstogetherwithpliers(notincluded), b lackto black(power),
white to white (neutral).Snip ends.Wrap the groundwire from
the outletbox aroundthe greenscrew preassembledon the
mountingbar (AA), and then connectthe ground wire from the
outlet box to the ground wire from the fixture.
Helpful hint: if the outlet box doesn't have a groundwire, you
can attachthe groundwire from the fixture directlyto the green
screw on the mounting bar (AA).
Attach wire connectors(DD) to ends.Tape wire connectors
(DD)andwirestogetherwithelectrical t ape(notincluded).
1
Model#: 203992A
Use and Care Guide
INTERIOR VANITY
Cap Nut
surface s uch as
c