Bell MAC-9 SENA Mode D'emploi

BELL English
Your new Mag-9 helmet is designed especially for the Bell SMHIO Bluetooth
Communication kit powered by SENAwhich is sold separately.
1. INSTALLING THE SMHIO ON YOUR HELMET
1 Remove the Left and Right side
cheekpads from the helmet
(attached by Velcro and 2 snaps )
BELL English
4 Now p ace the Sena C amp in the
space provided by the removal of
the EPS plug
BELL English
7 Open the Velcro closure on the
speaker pockets and
speakers inside before securely
closing again
MAC-9
ne Choice o/Pm/eUözaå
2 On the eft side, you will see a red tab.
Pul on this tab to remove the EPS p ug
5 Use the provided A1en wrench
and screw, and tighten
c amp is secure
8 Rep ace the cheekpads, pul the
place the chin straps through the openings in
the cheekpads,
2 snaps at the back of the helmet,
making sure the speaker wiring is
hidden beneath the padding
f;
6 Lift up the helmet top padding
until Sena from
(connected by 2 snaps) and route
the speaker wires beneath
padding
and then secure the
SENA
SEN A
SENA I SMHIO
3 Next, remove he trap door on the
eft side of the helmet
SENA
the back of the
SENA
9. You can now attach your Sena
SMHIO to the left Side of your
helmet
10. Place the helmet on your head
and adjust the microphone
your liking
SMHIO
helmet
the
SMHIO
boom to