HOMCOM YH-15-2 Manuel D'instructions page 4

Instructions to use
Switch on Product Remote control
① Power switch ON/OF.
② Heating setting: Heat power 750W and 1500W.
③ Flame color setting : five color cycle adjustments .
④ Timer: Timing 1-12 hours .
⑤ Temperature up setting .
⑥ Temperature down setting .
The device can be operated either via the controls on the device or by means of the
remote control.
1. Press the power switch button① to turn on the fireplace.
2. Press the heating button to switch power②, with high power displaying HI
(1500W) and low power displaying LO (750W)
3. Press the temperature setting button⑤⑥ to adjust the temperature, with a
temperature setting range of 15-35 °C. Press the up button to increase the
temperature, and press the down button to decrease the temperature. The default
temperature is 25 °C.
4. Press the flame color button③ to set the flame color change, there are five coloe
cycle adjustments.
5.Press the timer button④ to set the timer function, 01-12 hours
Overheating safe device
If the heater stops working, turn the heater off and inspect the blockage of inlet or
outlet. Disconnect the plug and wait at least 10 minutes for the protection
system to reset before attempting to restart the heater. If the safe device still
switches the heater off and makes the heater fail to operate, take the heater to your
nearest service center for examination or repair.
Attention: before restarting the heater, the plug must be disconnected for at
least 10 minutes
3