Progress Lighting 8519 Instructions De Montage Et D'installation

RESS '+PRPC
LIGHTING
WARNING:
1. DO NOT install transformer or lighting fixtures within 10ft of a pool, spa or fountain.
2. DO NOT use with an extension
3. Use With landscape lighting systems only
4. Do not connect two or more tranformers
5. Not for use •n dwellings
6. This transformer shall be connected
7 This product contains chemicals known to the State of California to cause cancer, birth defects and lor other reproductive
harm. Thoroughly wash hands after Installing, handling, cleaning, or otherwise touching this product
Installing the Transformer
1 Mount the transformer to a solid surface using the keyhole slots in the mounting bracket. (NOTE: the transformer must be
mounted at least one foot above ground level With the wire termnals facing down )
Split 12/2 cable approximately 3 inches, and strip 1/2 inch Insulation off each wire. 12/2 cable is the heavy black cable to
2
which all 12-volt low voltage lighting fixtures Will be connected
3. Insert one bare wire into the terminal block marked COM and tighten screw. Insert the other bare wire Into the terminal
block marked with the appropriate voltage (12V, 13V, 14V or 15V) and tighten screw NOTE Do not energize transformer
until installation is complete
Note: 600 watt transformers
Electrical Protection
This unit has dual circuit protection. The primary or 120V side of the transformer is thermally protected and will automatically
shut off when overheated
more than one 300 watt circuit, each circuit has a circuit breaker.
total lamp wattage exceeds the rated wattage of the circuit. If the total lamp wattage exceeds the rated wattage of the circuit,
reduce the wattage by using lower wattage lamps in the fixtures or reducing the number of fixtures on the circuit To reset the
breaker, push the toggle to the "ON" position. If the breaker trips again, check for an overload or a short circuit. If the unit
continues to cycle on and off, have the system Inspected by a qualified electnc•an.
A. Mount Bracket
Corchete de Montaje
Support de Monter
B. Power Supply
Summstro de Electricidad
L 'alimentation du Courant
C. Cover
Cubierta
Couvercle
D. Terminal Block
Bloque Terminal
Bloc de la Borne
E Circuit Breaker
Disyuntor
Disjoncteur
F. 120V Input Conductors
Conductores de Entrada
Conducteur D'Entrée
Assembly
CAUTION: Read instructions
circuit breaker panel before beginning installation.
8519, 8520, 8521, 8522, 8523
cord
in parallel.
to a 115/120 volt covered
have (2) 300 watt circuits and 900 watt transformers
The secondary or low-voltage Side ISprotected by a arcuit breaker. Note: On transformers With
c
de 120V
120V
& Installation
carefully and turn electricity off at main
GFCI receptacle marked "Wet Location".
have (3) 300W orcults.
The circuit breaker will trip if there IS a short circuit or if the
0
*ROCRESS
—ääääÉi
P8519 SHOWN
PAGE 1 of 2
Instructions
SPEC.NO. 93039138 (10-14-11)