PoolMaster 52505 Mode D'emploi

Poolside
52505
POOLMASTER
\vAv/e V\/ater
770 Del Paso Road, Sacramento,
Top Post with
Pre-Drilled Holes
23
Connector
Bottom Post
23 13/4"
Base Cap
Towel Tree
!
CA 95834-0308
e Top Cap
End Caps (6)
CrossBars
23 1/2"X1" (3)
0
Set Screw
Support Base
O FillSupport Base with sand(preferred)or waterusing
the fill hole. Insert the Base Cap.
@Connect the Bottom Postto the TopPostusingthe
Connector. Tap lightly with a Rubber Mallet until both
ends are fully seated on the center ring.
@ Insertthe TopCaponto the end of theTop Postand
tap lightly with a Rubber Mallet to fully seat.
O Insertthe (6) EndCapsonto eachend of the (3)Cross
Bars.Tap lightly with Rubber Mallet to fully seat (if
O
necessary).
Insert the (3) Cross Bars through the pre-drilled holes
in the Top PVCPost. Position each Cross Bar at the
"half-way" point or you may "off-set" them if desired.
Insert the completed "Tree" into the Baseand secure
with Set Screw.
Phillips Screwdriver
Questions
800.854.1492
Rubber
or comments? Call:
poolmaster.com
inf0@pooImaster.com
Mallet
O